BIBO BIBO10101 Hot and Cold Filtered Water Dispenser

User Manual - Page 19

For BIBO10101.

PDF File Manual, 24 pages, Download pdf file

Loading ...
Loading ...
Loading ...
BIBO BRIGHTER WATER 19
When you come back:
1. Turn on the water supply to your BIBO by twisting the blue tap so the lever is in line with the water pipe.
2. Turn the hot tank switch at the back your BIBO to on (‘1’).
3. Touch the hot water key
 again to stop.
4. The hot water tank will now begin heating.
5. It is a good idea to rinse fresh water through both tanks so remove the drip tray and place a jug or similar container
of at least 2l litres capacity under the taps then follow steps 6 and 7 below.
6. Touch the cold key
and allow the water to run until it stops automatically after dispensing approximately 1.5 litres.
7. Repeat this process by touching the hot key
noting the water will be hot!
8. The hot tank will now take approximately 5 minutes to reach maximum temperature,.
9. Check that the day/date/time and other settings are correct. If not then follow the instructions on pages 8, 9 and 10 of
your BIBO User’s Manual.
Disconnecting your BIBO when moving home
1. Turn off the water supply to your BIBO where it is connected to your mains water pipe. Normally this connection
consists of a white plastic ‘T’ connector with an integral shut-off valve. Turn the water off by twisting the grey lever
through 90 degrees. If the connection is by way of a traditional ‘washing machine’ type valve twist the blue lever
through 90 degrees.
2. Back at your BIBO touch the
to relieve any pressure in the pipe. A small volume of water may be dispensed. Touch
the key again.
3. Turn the power and hot tank switches at the back of your BIBO to off (‘0’).
4. At the water connection on the back of your BIBO, twist the blue tap lever so it is at right angles to the water pipe.
Where the pipe enters the tap, depress the collar and remove the pipe.
5. This length of water pipe should NOT be used again but can be removed from behind/under your kitchen units and
disconnected from the ‘T’ connector or ‘washing machine’ valve.
6. 
7. To re-install your BIBO in your new home please make an appointment with one of our professional installers or ask a

Safety tips:
As your BIBO is full of water it now weighs 20kgs so take care when lifting it.
It is important that your BIBO is kept upright during transportation
Loading ...
Loading ...
Loading ...