Loading ...
Loading ...
Loading ...
2
Installation instructions
Unpacking
To ensure the best performance from your new
washer please follow the instructions below.
Removing the packaging
1
Remove the outer packaging.
2
Tilt the machine backwards and walk it off the bottom
packer one foot at a time.
3
Remove the bottom packer from under the machine by
pulling it out the front.
4
Lift the lid and remove the bowl packer from the bowl.
5
Remove the hoses and accessories.
6
Keep the bottom packer and bowl packer in case they
are required for future transit.
Important!
Please ensure that the bottom packer has been removed before operating your machine.
In your clothes washer you will find:
1 hose guide
2 inlet hoses
4 rubber foot inserts (if not already inserted into the feet of your washer)
1 user guide
Location
Your washer must be installed on a level surface, and not on any textured floor coverings
(egcarpet, rugs) to ensure that the opening at the bottom of the machine is not obstructed.
Drain hose
1
Carefully pull the drain hose out from the back of
the machine by pulling the exposed part of the
hose upward and outward.
2
To guide the drain hose over the tub or standpipe
the hose guide MUST be fitted to the drain hose.
To prevent syphoning:
The drain hose should not extend more than
20mm from the end of the guide.
The height of the standpipe or tub should be
between 850 – 1200mm.
The drain hose can be trimmed to length.
3
Place the drain hose in the tub or standpipe.
Fig.1 Tilt washer backwards to remove packer
Pull hose
through
guide
Flex hose
guide apart
Standpipe 850 – 2400 mm
(20 mm)
maximum
Fig.2 Fitting the drain hose guide
Loading ...
Loading ...
Loading ...