Loading ...
Loading ...
Loading ...
9
2. Connect the 2 white wires (D) and the green (or bare) ground
wire (of the oven cable) using a UL-listed wire connector.
3. Connect the 2 red wires (G) together using a UL-listed wire
connector.
4. Install junction box cover.
Install Oven
1. Using 2 or more people, lift the oven partially into the cabinet
cutout. Use the oven opening as an area to grip.
NOTE: Push against seal area of the oven front frame when
pushing the oven into the cabinet. Do not push against the
outside edges.
2. Push against the seal area of the front frame to push the
oven into the cabinet until the back surface of the front frame
touches the front wall of the cabinet.
3. Push oven completely into the cabinet and center the oven
into the cabinet cutout.
4. Remove the tape from the black front trim.
■ Securely fasten the oven to the cabinet using the
#8-14 x 1" (2.5 cm) screws provided.
■ Insert the screws through holes in black trim, aligning
with the holes in oven frame and mounting spacers
already in place. Do not overtighten screws.
5. The bottom vent and bottom vent trim (required when the
oven is installed with the feet in the tall position) are shipped
in the foam packing at the top of the oven.
To install only the bottom vent, see the following instructions.
To install both the bottom vent and the bottom vent trim
for installations with the feet in the tall position, see the
instructions in Step 6.
■ Align vent tab (B) with oven frame (A) as shown.
■ Using one #8-18 x 3/8" (9.5 mm) screw (D) on each side
of the vent tab (B), fasten the vent securely to the oven.
6. On models with the feet installed in the tall position, the
bottom vent trim must also be installed. See the following
instructions to install.
■ Flex the upper vent piece (C) away from the lower vent
piece (D) to slide the bottom vent trim (B) between them.
Some force may be required to ex the upper vent trim
(C) away from the lower vent trim (D). Some force may
also be required to ex the bottom vent trim (B) and
slide it into position. Make sure screw holes are properly
aligned between the two pieces. See the following
illustration.
■ Install the bottom vent trim (B) to the lower vent piece (D)
using two #8-18 x 1/4" (6.4 mm) screws on each side.
A
B
C
A. Oven frame
B. Oven frame hole
C. Black trim piece
A
C
D
B
A. Oven frame
B. Vent tab
C. Oven vent
D. #8-18 x 3/8" (9.5 mm) screws
D
B
A
C
B
D
C
A. #8-18 x 1/4"
(6.4 mm) screw
B. Bottom vent trim
C. Upper vent piece
D. Lower vent piece
Loading ...
Loading ...
Loading ...