Loading ...
Loading ...
Loading ...
18
English
Explanation of buttons
MODE
- Press MODE button to select console functions;
Time, Speed, Dist, ODO, Cal. & Pulse
- Push and hold for 4 seconds to reset: Time,
Count, Dist & Calorie.
SET
Set the values for: Time, Count, Dist & Calorie
when not in scan mode.
- Press SET button to set console in goal input
mode.
- Press MODE to select goal you like to set. (the
selected goal will blink when able to set value.)
- Press SET Button to higher the goal input, hold
SET button to higher the value fast.
- Press RESET button shortly to reset the
changed selected goal.
- Press MODE Button to active next optional goal
to be set.
TIME + 1 min ( 1 ~ 99)
SPEED ( max. 99,9 Km/h)
DIST + 0,5KM ( 0,5KM ~ 99,50Km )
ODO ( max. 999,9 Km)
CAL + 1 ( 1 ~ 999 )
PULSE + 1 ( 40 ~ 240 )
‼ NOTE
• When you set a goals the set goal value will
Count down in active mode.
• When goal is reached the console will
notify by 4 dual acoustic beep signals. The
reached value will now Count up starting
from “0”.
• You can set more than one goal, all goals
will notify when goal is reached.
RESET
- Push and hold for 4 seconds to reset: Time,
Dist., Cal., & Pulse
‼ NOTE
• Total Count can only be reset by a batteries
exchange.
Extra notes
- If the display is faint or shows no figures, please
replace the batteries.
- The monitor will automatically shut off if there is
no signal received after 4 minutes .
- The monitor will be auto-powered on when
starting to exercise push button w/signal in.
- The monitor will automatically start calculating
when you start to exercise and will stop
calculating when you stop exercising for 4
seconds .
Cleaning and maintenance
The equipment does not require special
maintenance. The equipment does not require
recalibration when it is assembled, used and
serviced according to the instructions.
⚠ WARNING
• Do not use solvents to clean the equipment.
• Clean the equipment with a soft, absorbent
cloth after each use.
• Regularly check that all screws and nuts
are tight.
• If necessary, lubricate the joints.
Replacing the batteries (Fig E )
The console is equipped with 2 AA batteries at
the rear of the console.
- Remove the cover.
- Remove the old batteries.
- Insert the new batteries. Make sure that
batteries match the (+) and (-) polarity markings.
- Mount the cover.
Defects and malfunctions
Despite continuous quality control, defects and
malfunctions caused by individual parts can
occur in the equipment. In most cases, it will be
sufficient to replace the defective part.
- If the equipment does not function properly,
immediately contact the dealer.
- Provide the model number and the serial
number of the equipment to the dealer. State
the nature of the problem, conditions of use
and purchase date.
Trouble shooting:
- When the display of LCD is dim, it means the
batteries need to be changed.
- If there is no signal when you pedal, please
check if the cable is well connected.
Loading ...
Loading ...
Loading ...