Loading ...
Loading ...
Loading ...
17
Connecting to the Water Filter
There are two types of filters. The methods of
connection are different. One has a threaded
plastic nut fitting and the other uses a self
locking push fit connectors. The filter is marked
with the direction of the water flow from the
water tap to the appliance.
<Nut Type>
1
Unscrew the threaded connector and place
it over the end of the cut section of pipe
coming from the appliance. Push the pipe
over the end of the filter that the flow arrow
points to and tighten up the threaded
connector.
2
Repeat the same process on the other end
of the filter using the remainder of the
water tube.
<Push fit Connector Type>
1
Firmly push the water tube connected from
the appliance into the end that has the
arrow pointing outward. Push the tube all
the way in (approx. 10-12 mm).
2
After inserting the tube securely into the
filter, fit the locking clip into position under
the pull up collar.
3
Repeat on the other end of the filter using
the remainder of the water tube.
Connecting to the Water Tap
1
Push the water tube into the hole of the tap
connector supplied in the accessories. The
pipe should be held firmly whilst the
connector is pushed onto the pipe.
2
Ensure that the rubber washer is fitted
inside to the inside of the tap connector
before screwing it onto the tap.
Checking the Water Connection
1
Turn on the water supply and switch on the
appliance. Carefully check all fittings for
possible leaks due to poorly fitted hoses.
2
Press and hold the Water Filter button for
three seconds. That resets the
Replacement Filter icon. The new water
filter has been activated.
3
Place a cup under the water dispenser to
verify that water is flowing through the
appliance.
4
Check the connecting tube and joints for
leaks once again.
5
The water filter should be fixed at a
appropriate place where it is easy to reach
for replacement purposes.
EN
Loading ...
Loading ...
Loading ...