Loading ...
Loading ...
Loading ...
29
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted.
To adjust the drive belt, first press the power switch
to the off position and unplug the power cord.
Next, use
a standard
screwdriver to
remove the Shield
Cover (75) and the
Shield Cover Cap
(118).
See assembly step 15 on page 15. Remove the
Right Leg Outer and Inner Covers (69, 83).
See assembly step 12 on page 13. Remove the
Right Pedal Arm (58) from the Right Upper Body
Leg (60).
Next, remove the M8 x 16mm Screw (95) and the Axle
Cover (53) from the right Crank Arm (20). Then, care-
fully remove the Right Roller Arm (59) and the Right
Pedal Arm (58) from the elliptical.
See EXPLODED DRAWING C on page 35. Identify
the Left and Right Shields (73, 74). Remove the
M4 x 19mm Screws (5), the M4 x 25mm Screws (127),
and the M4 x 48mm Screw (107) from the Left and
Right Shields; make sure to note the location of
each size of Screw. Then, remove the Right Shield.
Then, locate and loosen the Idler Screw (89). Tighten
the Belt Adjustment Screw (91) until the Drive Belt
(113) is tight. Then, retighten the Idler Screw.
Reattach the parts that you removed. Then, plug in the
power cord.
75
118
59
20
95
58
53
113
91
89
Loading ...
Loading ...
Loading ...