Loading ...
Loading ...
Loading ...
8
Installing Your Door Handles and Shelves
INSTALLING THE DOOR HANDLES:
1. Open the door and carefully pull back the door gasket around the area where the handle is to be installed.
2. Insert each Phillips head screw through the gasket side of the door until the screw pass through the door.
3. Align the handle with the screws and tighten using a Phillips head screwdriver until the handle is flush against the
door frame. CAUTION: Do not over-tighten the screws as this may cause damage to the handle or to the stainless
steel door.
4. Carefully press the door gasket into its original position.
5. Repeat steps 1-4 for the second door.
INSTALLING THE SHELVES:
1. Open the door completely.
2. Push the shelf tracks affixed to the walls of the inner cabinet to the rear of the unit so that the tracks are fully seated
inside the cooler compartment.
3. Line up the rails affixed to the shelf with the corresponding wine cooler tracks attached to the inner cabinet walls.
4. Push the front of the shelf inwards evenly until the shelf rests fully inside of the unit and you are able to close the
door.
5. The shelf should glide smoothly back and forth. If it does not, you may need to remove it and start over.
REMOVING THE SHELVES:
1. Open the door completely.
2. Remove all of the contents loaded on the shelf, if applicable.
3. Pull the shelf towards yourself until it is fully extended outward.
4. The shelf has plastic posts on both sides as indicated in the diagram below. While facing the unit, press the plastic
post on the right side down while pulling up on the left plastic post. You may choose to do this by hand or by using a
flathead screwdriver.
5. Evenly pull out the shelf from the track until it is completely removed from the inner compartment.
TIP: To prevent damaging the door gasket, make sure to open the door fully before pulling the shelves out of their track.
Loading ...
Loading ...
Loading ...