Loading ...
Loading ...
Loading ...
MK / MKT (E5) 08/2020 page 12/162
During and shortly after operation, the temperature of the inner surfaces almost equals the set-point. The
window, the access ports and the inner chamber will become hot during operation.
CAUTION
Danger of burning by touching hot chamber parts during operation.
Burns.
∅ Do NOT touch the inner surfaces, the front panel around the inner chamber, the win-
dow, the access port area or the charging material during operation.
WARNING
Danger of injury and damages by the chamber tipping over or breakaway of the pro-
truding lower housing cover.
Injuries and damage to the chamber and the loading material
∅ Do NOT load the lower housing cover with heavy objects while the chamber door is
open and do NOT climb on it.
1.8 Intended use
Following the instructions in this operating manual and conducting regular maintenance
work (chap. 21) are part of the intended use.
Any use of the chambers that does not comply with the requirements specified in this Operating
Manual shall be considered improper use.
Other applications than those described in this chapter are not approved.
Use
Alternating climate chambers MK / MKT are suitable for temperature treatment of solid or pulverized charg-
ing material, as well as bulk material, using the supply of heat or cold.
The chambers can be used for drying processes, but they are particularly suitable for all tasks that occur in
materials testing and aging tests. The chambers are suitable for harmless materials.
Do NOT use the chamber for drying purpose, especially if greater quantities of steam leading to conden-
sation will be set free.
Requirements for the chamber load
Any solvent must not be explosive and flammable. A mixture of any component of the charging material
with air must NOT be explosive. The operating temperature must lie below the flash point or below the
sublimation point of the charging material. Any component of the charging material must NOT be able to
release toxic gases.
The charging material shall not contain any corrosive ingredients that may damage the machine compo-
nents made of stainless steel, aluminum, and copper. Such ingredients include in particular acids and hal-
ides. Any corrosive damage caused by such ingredients is excluded from liability by BINDER GmbH.
Loading ...
Loading ...
Loading ...