Loading ...
Loading ...
Loading ...
21
Cleaning the Machine
Clean the machine with a soft cloth and a neutral pH cleaner.
With scrub head resting in the vertical position, rinse bearing while rotating the pad driver or brush. Before emptying
the solution tank, adjust the handle to the middle position so that the water drains behind the machine.
Changing The Driver Grip Face
Remove the ten outer screws that fasten the grip face disc on the driver plate. To save time, use an electric
screwdriver with a #3 Phillips Head bit.
The Number #3 Phillips head bit is slightly larger than standard size. It is important that you are using a #3
Phillips Head bit, as smaller bits can damage the screw heads and produce sharp edges which can
damage the cleaning pads. Attach a new grip face disc to the driver plate using the ten screws.
L'embout de tournevis Phillips numéro 3 est légèrement plus grand que la taille standard. Il est important
que vous utilisiez un embout de tournevis Phillips numéro 3, puisque des embouts de taille inférieure
peuvent endommager les têtes de vis et laisser des arêtes vives, qui peuvent endommager les tampons de
nettoyage. À l'aide des dix vis, fixez un nouveau disque à face de préhension à la plaque d'entraînement.
Make sure that the screws are very tight, not loose. If the screws are even slightly loose it can cause
damage to the grip face disc. Ensure that the four holes in the middle of the grip face disc are aligned with
the screws located on the driver plate. An exact alignment allows easy removal and installation of the
driver plate.
Assurez-vous que les vis sont bien serrées. Même un léger desserrement des vis peut endommager le
disque à face de préhension. Assurez-vous que les quatre trous au milieu du disque à face de préhension
sont alignés avec les vis situées sur la plaque d'entraînement. Un alignement exact permet de retirer et
d'installer facilement la plaque d'entraînement.
8.638-856.0 Manual Operators - Radiant Orbital Scrubber
Loading ...
Loading ...
Loading ...