Loading ...
Loading ...
Loading ...
11
CO
2
Regulator and CO
2
Cylinder
NOTE: Your CO
2
cylinder is shipped empty to avoid any possible accidents during transportation. When
you purchase the first keg of beer, have your beer distributor fill the CO
2
cylinder. You must read and
understand the following procedures for CO
2
cylinders before installation:
1. Install the CO
2
gas line tube to the regulator by attaching one end of the red tube to the hose
connection on the CO
2
regulator.
2. Secure the tube by using one of the self-locking black plastic snap-on clamps.
3. Insert a special washer into the regulator-to-cylinder attachment nut.
4. Attach the CO
2
regulator to the CO
2
cylinder by screwing the regulator nut onto the cylinder valve and
tightening with an adjustable wrench.
5. Remove the bolt with the nut from the cylinder retainer. Using two screws, attach it inside the unit on
the left side of the back wall. Holes are pre-drilled and screws are included.
6. Slide the cylinder through the retainer and secure it with the bolt and the nut. Position the cylinder
this way so that you will be able to read the numbers on the gauges and easily access the shut-off
valve.
Installation of Accessories
1.
Once the unit has been positioned under the counter, install the beer tower assembly and the mixed
ball valve:
a.
Lower the beer tower through the hole in the counter and into the hole at the top of the beer
dispenser’s
upper surface. Be sure the tap is facing toward the front of the machine.
b.
Take out the accessories of the mixed ball valve. Attach the transparent hose to the beer
outlet of the
mixed ball valve. (See Figure 5).
2.
Install CO
2
gas cylinder and CO
2
regulator valve:
a.
Fix the two CO
2
hose clamps on the red CO
2
tube (See Figure 6).
b.
Connect the ends of the red CO
2
tube respectively to the CO
2
intake port of the mixed ball valve
and the
round outlet of the CO
2
regulator valve. Lock these connections firmly with the two
clamps on the red CO
2
tube (See Figure 7).
c.
Using the wrench, tighten the CO
2
regulator table valve with the hex nut port to the gas outlet
of the CO
2
tank (See Figure 9).
Loading ...
Loading ...
Loading ...