Loading ...
Loading ...
Loading ...
7
Add Detergent
NOTE: If you do not plan to run a wash cycle soon, run a rinse
cycle. Do not use detergent.
■ Use automatic dishwasher detergent only. Add detergent just
before starting a cycle.
■ Fresh automatic dishwasher
detergent results in better
cleaning. Store tightly
closed detergent container
in a cool, dry place.
Premeasured Detergents
Many detergents now come in premeasured forms (gel packs,
tablets, or powder packs). These forms are suitable for all hardness
and soil levels. Always place premeasured detergents in main
compartment and close lid.
Using dishwasher detergent tablets and packs have been proven
better than powder, liquid or gel detergents at reducing filming on
dishes. Using tablets and packs over time will start to reduce or
eliminate white film. Also, by using a rinse aid you can minimize
repeat buildup of white film.
Powders and Gels
■ The amount of detergent to use depends on:
How much soil remains on the items - Heavily soiled loads
require more detergent.
The hardness of the water - If you use too little in hard water,
dishes won't be clean. If you use too much in soft water,
glassware will etch.
Soft to Medium Water (0-6 grains per U.S. gallon)
[typical water softener water and some city water]
Medium to Hard Water (7-12 grains per U.S. gallon)
[well water and some city water]
■ Depending on your water hardness, fill the Main Wash section
of the dispenser as shown. Fill the Pre-Wash section to the
level shown, if needed.
NOTE: Fill amounts shown
are for standard powdered
detergent. Follow
instructions on the package
when using other dishwasher
detergent types.
Add Rinse Aid
■ Your dishwasher is designed to use rinse aid for good drying
performance. Without rinse aid your dishes and dishwasher
interior will have excessive moisture. The heat dry option will
not perform as well without rinse aid.
■ Rinse aid keeps water from forming droplets that can
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes after the final
rinse.
■ Rinse aid helps to reduce excess moisture on the dish
racks and interior of your dishwasher.
■ Check the rinse aid indicator. Add rinse aid when indicator
drops to “Add” level.
■ To add rinse aid, turn the
dispenser cap to “Refill”
and lift off. Pour rinse aid
into the opening until the
indicator level is at “Full.”
Replace the dispenser
cap and turn to “Lock.”
Make sure cap is fully
locked.
NOTE: For most water conditions, the factory
setting of 3 will give good results. If you have
hard water or notice rings or spots, try a higher
setting. Turn the arrow adjuster inside the
dispenser by either using your fingers or
inserting a flat-blade screwdriver into the center
of the arrow and turning.
Select a Cycle (cycles vary by model)
See “Cycle and Option Descriptions” charts in the following
section.
Efficient dishwashers run longer to save water and energy, just as
driving a car slower saves on gas. Typical cycle time is
approximately 2¹⁄₂ hours, but can take less or more time to
complete depending on selections.
Select Options (options vary by model)
See “Cycle and Option Descriptions” charts in the following
section.
You can customize your cycles by pressing the options desired. If
you change your mind, press the option again to turn off the option.
Not all options are available for every cycle. If an invalid option is
selected for a given cycle, the lights will flash.
Start or Resume a Cycle
NOTE: Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water.
■ Push door firmly closed within 3 seconds of
pressing START/RESUME. If door is not closed
within 3 seconds, the Start indicator will flash,
an audible tone will be heard, and cycle will not
start.
IMPORTANT: If anyone opens the door (such as, for adding a dish,
even during the Delay Hours option), the Start/Resume button
must be pressed each time.
■ Press START/RESUME to repeat the same cycle and options
as in the previous wash cycle.
STEP 2
Soft Water
Hard Water
Soft Water
Hard Water
Main Wash Pre-Wash
Full
Add
STEP 3
STEP 4
Loading ...
Loading ...
Loading ...