Loading ...
Loading ...
Loading ...
34
Performance Data Sheet
SmartWater Filtration System-GE
®
MSWF Cartridge
This system has been tested and certifi ed in lter model GE MSWF according to NSF/ANSI Standards 42 and 53 for reduction of the substances listed below.
The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water
leaving the system, as specifi ed in NSF/ANSI Standards 42 and 53.* (Safety factors built in for unmetered usage.)
It is essential that the manufacturer's recommended installation, maintenance and fi lter replacement requirements be carried out for the product to perform as advertised.
See insert for Warranty information.
Application Guidelines/Water Supply Parameters
Service Flow 0.9 gpm (3.14 lpm)
Water Supply Potable Water
Water Pressure 40–120 psi (2.8–8.2 bar)
Water Temperature 33ºF–100ºF (0.6ºC–38ºC)
Operating Specifi cations
• Pressure requirement: 40–120 psi (2.8–8.2 bar), non-shock
• Temperature: 33–100°F (0.6–38°C)
• Flow rate: 0.9 gpm (3.14 lpm)
General Installation/Operation/Maintenance Requirements
lluf ta egdirtrac wen hsulF ow for 4-1/2 gallons (about ve minutes) to purge
trapped air.
Replace cartridge when fl ow becomes too slow.
gnivomer yb gnizeerf morf tcetorP lter cartridge when temperatures are
erehw saera ni smetsys llatsni ton oD .)C°4.4( F°04 woleb pord
ot detcepxe
llatsni ton oD .F°04 woleb ro Fº001 evoba og yam serutarepmet tneibma
on a hot water supply.
Special Notices
.deppihs nehw tcudorp eht htiw dedulcni era snoitcurtsni noitallatsnI
srerutcafunam ot gnidrocca
deniatniam eb tsum metsys retaw gniknird sihT
instructions, including replacement of fi lter cartridges.
-htiw ytilauq nwonknu fo ro efasnu yllacigoloiborcim
si taht retaw htiw esu ton oD
out adequate disinfection before or after the system. Systems certifi ed for cyst
reduction may be used on disinfected water that may contain fi lterable cysts.
Standard No. 42: Aesthetic Effects
lacimehC
– Chlorine Taste and Odor
Tested and Certifi ed by NSF International against ANSI/NSF Standards 42 and 53 in model GE MSWF for the reduction of:
noitartliF lacinahceM
– Particulate Reduction, Class I
Standard No. 53: Health Effects
noitcudeR lacimehC
Atrazine Reduction
Endrin Reduction
– Benzene and Carbofuran Reduction
dna enezneborolhciD 4,1
2,4-D Reduction
Lead and Lindane Reduction
– Mercury and Toxaphene Reduction
noitartliF lacinahceM
Cyst and Asbestos Reduction
retaw siht yb decuder ro devomer secnatsbus rehto ro stnanimatnoc ehT
treatment system are not necessarily in your water.
.snoitaluger dna swal lacol
dna etats elbacilppa eht htiw ecnailpmoc rof kcehC
,snoitidnoc yrotarobal dradnats rednu demrofrep
saw gnitset eht elihw taht etoN
actual performance may vary. Systems must be installed and operated in
accordance with manufacturer’s recommended procedures and guidelines.
ton oD .sedoc gnibmulp lacol dna etats lla htiw ylpmoc TSUM esu d
na noitallatsnI
install if water pressure exceeds 120 psi. If your water pressure exceeds 80 psi
(552 kPa), you should install a pressure-limiting valve. Contact a plumbing
professional if you are uncertain how to check your water pressure.
remmah retaw fI .rucco yam snoitidnoc remmah retaw erehw llatsni ton oD
conditions exist you must install a water hammer arrester. Contact a plumbing
professional if you are uncertain how to check for this condition.
kca
b a erehW ow prevention device is installed on a water system, a device for
controlling pressure due to thermal expansion must be installed.
For conditions of use, health claims certifi ed by the California Department of Public
Health, and replacements, see performance data sheet. California Department
of Public Health Certifi cation #06-1834. The contaminants or other substances
removed or reduced by this water fi lter are not necessarily in all users’ water.
GE
Appliances
Appliance Park
Louisville, KY 40225
geapplianceparts.com
© 2010 General Electric Company PC61577C
TNEMELE TNEMECALPER
Standard No. 42: Aesthetic effects
Parameter USEPA MCL
Infl uent Challenge
Concentration
Effl noitcudeR %tneu
Min. Required ReductionAverage Maximum Average Maximum
Chlorine Taste & Odor 2.0 mg/L ± 10% 0.06 mg/L 0.10 mg/L 97% 9.1% ≥ 50%
Particulate** at least 10,000 particles/
mL
408,333 670,000 95.5% 89.4% ≥ 85%
Standard No. 53: Health effects
Parameter USEPA MCL
Infl uent Challenge
Concentration
Effl noitcudeR %tneu
Max. Permissible
Product WaterAverage Maximum Average Maximum
Turbidity 1 NTU**** 11 ± 1 NTU**** 0.38 NTU 0.5 NTU 96.5% 95.4% 0.5 NTU
Cysts*** 99.95% Reduction Minimum 50,000 L < 1 #/L 4 #/L > 99.99% > 99.99% 99.95%
Lead at pH 6.5 0.010 mg/L 0.15 mg/L ± 10% < 1 ppb < 1 ppb 99.3% 99.3% 0.010 mg/L
Lead at pH 8.5 0.010 mg/L 0.15 mg/L ± 10% 3.1 ppb 9.0 ppb 98.0% 95.5% 0.010 mg/L
Mercury at pH 6.5 0.002 mg/L 0.006 mg/L ± 10% 0.34 ppb 0.7 ppb 94.0% 89.6% 0.002 mg/L
Mercury at pH 8.5 0.002 mg/L 0.006 mg/L ± 10% 0.66 ppb 1.5 ppb 88.4% 73.7% 0.002 mg/L
Lindane 0.0002 mg/L 0.002 mg/L ± 10% < 0.02 ppb < 0.02 ppb > 99.0% > 99.0% 0.0002 mg/L
Atrazine 0.003 mg/L 0.009 mg/L ± 10% < 0.5 ppb < 0.05 ppb > 93.9% > 94.3% 0.003 mg/L
2, 4-D 0.070 mg/L 0.210 mg/L ± 10% 7.7 ppb 35 ppb 96.0% 82.0% 0.070 mg/L
Toxaphene 0.003 mg/L 0.015 mg/L ± 10% < 1 ppb < 1 ppb > 92.9% > 92.9% 0.003 mg/L
Benzene 0.005 mg/L 0.015 mg/L ± 10% < 0.5 ppb < 0.5 ppb > 96.8% > 97.0% 0.005 mg/L
Carbofuran 0.040 mg/L 0.080 mg/L ± 10% < 1 ppb 1 ppb > 98.7% > 98.7% 0.040 mg/L
P-Dichlorobenzene 0.075 mg/L 0.225 mg/L ± 10% < 0.5 ppb < 0.5 ppb > 99.7% > 99.8% 0.075 mg/L
Asbestos 99% Reduction 10
7
to 10
8
bers/L;
bers > 10μm in length
< 0.17 MF/L < 0.17 MF/L > 99% > 99% 99% Reduction
*Tested using pressure of 60 psig; pH of 7.5 ± 0.5; temp of 68º ± 5ºF (20º ± 2.5ºC).
**Measurement in Particles/mL. Particles used were 0.5-1 microns.
***Based on the use of Cryptosporidium parvum oocysts.
****NTU=Nephelometric Turbidity Units
Capacity 300 gallons (1,135 liters). Contaminant reduction determined by NSF testing.
EPA #10350-MN-005
(on some models)
Loading ...
Loading ...
Loading ...