Loading ...
Loading ...
Loading ...
P/N 750323 Page 23
All specifications are subject to change without prior notification.
OVEN BURN-OFF PROCEDURE
As part of installation protective plastic
wrappers on stainless steel surfaces
should be removed. These wrappers
must be removed before operation.
New appliances are wiped clean with
various cleaners and solvents to remove
visible signs of dirt, oil and grease be-
fore leaving the factory.
Before turning on your oven for the first
time, remove the broiler pan, oven
racks, and rack guides and wash them
with hot soapy water. Thoroughly rinse
and dry items and replace them.
During initial start-up, after all perform-
ance checks and adjustments, the oven
should be allowed to heat to burn off
any oils or solvents from internal parts.
The presence of such coatings is normal
as part of the manufacturing process.
Follow the user instructions to light the
oven. Once lit set the temperature ad-
justment to 300º.
Allow the oven to pre-heat at least 10
minutes before turning on the convec-
tion fan.
After approximately 30 minutes in-
crease the temperature setting to 450º
and allow to heat for another hour.
During this process a strong odor and/or
some smoke may be observed as any
oils and solvents on internal parts are
burned off. This is the primary reason
for the burn-off process.
NOTICE!
AIR SHUTTER ADJUSTMENTS
Air shutter adjustments are preset at the
factory. These adjustments may need to be
redone and/or fine tuned by the installer.
These adjustments are normal. They are
the responsibility of the qualified installer
and are not covered by your warranty.
CARE AND MAINTENANCE
Loading ...
Loading ...
Loading ...