Loading ...
Loading ...
Loading ...
PWM 908 en-GB
14 11 276 340/05
Securely connect the drain hose to a sink drain outlet
The drain hose can be connected securely to a suitable sink drain
outlet.
If required, the hose can be extended to a length of up to 5 m.
Accessories are available from the Miele Customer Service
Department or from your Miele dealer.
For a delivery head of more than 1 m (up to a max. of 1.6 m), a
replacement drain pump is available from the Miele Customer Service
Department or from your Miele dealer.
Equipotential bonding
If necessary, equipotential bonding with good galvanic contact must
be guaranteed in compliance with all applicable local and national
installation specifications.
Connection material for equipotential bonding must be provided on
site or using a kit available from the Miele Customer Service
Department.
Peak load / energy management
The appliance can be connected to a peak-load or energy
management system using an optional kit.
When the peak-load function is activated, the heating is deactivated.
An appropriate message appears in the display.
Liquid dispensing connection
External liquid dispenser pumps with a “container empty” indicator can
be used to dispense liquid detergents.
The dispenser pumps can only be programmed with MDU.
It is particularly important to observe manufacturer’s instructions when
using a combination of detergents, additives and special-purpose
products.
Payment system
This washing machine can be fitted with a single-machine payment
system as an optional accessory using an optional kit (XCI box).
The programming required for connecting a payment system can be
carried out during the initial commissioning process. After initial
commissioning, changes may only be carried out by your Miele dealer
or the Miele Customer Service Department.
Interface
The appliance can be fitted with an XKM 3200 WL PLT
communication module.
This module can be used as a WiFi or LAN interface.
The LAN interface provided via the module complies with SELV
(Safety Extra Low Voltage) in accordance with EN 60950. Connected
appliances must also comply with SELV. The LAN connection uses a
RJ45 connector in accordance with EIA/TIA 568-B.
Installation
The machine must be installed on a perfectly smooth, level and firm
surface which is able to withstand the quoted loads.
The floor load created by the machine is concentrated and transferred
to the installation footprint via the machine feet.
The machine should be levelled in both directions with the aid of the
adjustable feet.
Plinth installation
The washing machine can be installed on a machine plinth (open or
box plinth, available as an optional Miele accessory) or on a concrete
platform to be provided on site.
The quality of the concrete and its strength must be assessed
according to the machine load. Ensure that any raised concrete plinth
is adequately bonded to the concrete floor below!
If the washing machine is installed on a concrete or masonry plinth, it
must be secured using the anchors supplied with the machine.
Otherwise, there is the danger of the washing machine moving about
during spinning and falling off a plinth.
The anchors provided can be used to bolt the machine to the floor by
both front feet. The material provided is intended for use in bolting the
machine to a concrete floor.
Washer-dryer stack
The washing machine can be installed as a washer-dryer stack
together with a Miele tumble dryer. A stacking kit (optional accessory)
is required for this.
Installation of the stacking kit must be performed by the Miele
Customer Service Department or an authorised Miele service
technician.