Loading ...
Loading ...
Loading ...
15
Installing the appliance
1 Securely insert the front line into the appliance
(snaps into place). For this purpose, put the
appliance to be plugged in just on to the edge of
the unit. Plug the power cord into the socket.
Fig. 11
Plug transformer into dedicated receptacle in an
accessible cabinet adjacent to the coffee maker
(depends on the built-in situation). Do not plug into
a receptacle behind the appliance. Push the
appliance into the unit until it clicks into place.
Important: The socket must be freely accessible
after the appliance has been installed.
2 Check the water drainage. To do so, slowly pour
approx. 0.5 l water from a container, e.g. jug, into
the drip tray. The water must drain off completely.
Fig. 12
If the water fails to drain off, check installation of
the hose and the waste water connection according
to the information in these installation instructions.
3 Check that the appliance is in the middle. If
necessary, align the appliance. To do so, pull the
appliance out a little, remove the appropriate
spacers (e) and attach to the left side (top and
bottom). Push the appliance into the unit until it
clicks into place. Adjust the appliance so it is
aligned horizontally and vertically. The appliance
should not stand at an angle of more than 1° (2%)
in any direction! Fig. 13
4 Take hold of the appliance door on the right next to
the outlet and open. Remove the drip tray (Y). Pull
the cover (X) on the bottom left-hand side forwards
and remove. Pull out the accessories drawer (Z)
and put to one side. Fig. 14
5 First, screw on the appliance as shown using 2 of
each of the fastening screws (f) and (g) as well as 2
sleeves (j). Then screw tight at the top right of the
unit using 1 fastening screw (f) and sleeve (h).
Fig. 15
Then:
‒ Open the door at an angle of approx. 55°.
‒ Screw in the screws (n).
‒ Fit the hinge dampers (o).
6
Only for the qualified installer:
In very few cases, the door of the built-in fully
automatic coffee machine can jam due to a
misalignment in the cabinet where the unit is built
in. The door can be adjusted. To do this adjust the
hinges at the top and the bottom:
‒ Adjust the depth of the door by turning the
screws
(V). Fig. 16.I
‒ Remove the hinge dampers at the top and
bottom of the hinges. Turn the screws (W) to
adjust the inclination and the horizontal position
of the doors.
‒ Re-fit the hinge dampers. Fig. 16.III
7 Insert the cover (X) and fix with the two black
fastening screws (i). Fig. 17
8 Replace the drip tray (Y) and accessories drawer
(Z) and close the appliance door. Fig. 18
Loading ...
Loading ...
Loading ...