Loading ...
Loading ...
Loading ...
Additional Maintenance: Bin Controls, Condenser
The bin controls use a system of infrared emitting
and receiving components to sense the build up of
ice in the bin. They are located at the bottom of the
ice outlet port. They must be free of mineral build
up to function properly. To check:
1. Remove front panel.
2. Push and release the off button.
3. Remove top and right side panels.
4. Remove the evaporator cover (on models with
one)
5. Remove the cube deflector.
6. Pull up to remove the cascading shield (on
models with one)
7. Push into the freezing compartment the electric
eye brackets.
8. Examine the bottom of the brackets, there are
two sensors in each bracket, check that they are
clear of mineral build up. They may be wiped clean
with ice machine cleaner to assist in removal of
the build up. Be sure to drain the reservoir or go
thru a Clean cycle to remove residual cleaner.
Note: Do NOT use abrasive materials or cleaner
on the bin sensor lenses. A soft toothbrush is an
effective tool for cleaning these sensors.
Air Filter Replacement
To Clean the Air Cooled Condenser
Contact a refrigeration service technician if the air
cooled condenser coil needs to be cleaned.
CME256, 506, 656, 806: AutoIQ Cubers
January 2007
Page 14
Bin Control
Sensor, Electric
Eye Area
Bin Controls
in Reservoir
Cleaning of Bin Controls
Air Filter
Replacement
Loading ...
Loading ...