Loading ...
Loading ...
Loading ...
9
UNIT SETUP - Floor Stand
x2
x2
5. Use Two (2) M6*14 Bolts and Two (2)
Acorn Nuts to combine Top of Bracket
1 (Long End) to the Bottom of Bracket 2
(Short End) .
6. Use Two (2) M6*35 Screws and Two
(2) Wing Nuts to install the Front of
Bracket 2 (Long End) to the rear
of the Telescoping Post.
7. Use Two (2) M5*12 Screws to install
Bracket 1 (Short End) to the rear of
the Heater Body.
8. Use the Two (2) remaining M5*12 Screws
to mount the Grille Guard to the rear of
the Heater Body. The Grill Guard should
extend over the front of the unit.
9. Loosen the Telescoping Lock and slide
the pole and unit up or down to your
desired height, then re-tighten the
Telescoping Lock.
Loading ...
Loading ...
Loading ...