Loading ...
Loading ...
Loading ...
10
UNIT SETUP - Wall Mount
1. Ensure the desired mounting location can t the unit in a horizontal orientation and is
near an outlet but free from electrical cables, communication lines, and pipes that
could be damaged by excessive heat.
2. If needed, pre-drill your wall and insert
3 Wall Anchors. Use Bracket 2 as a
template for hole placement.
3. Use Two (2) M6*14 Bolts and Two (2) Acorn
Nuts to combine Top of Bracket 1 (Long
End) to the Bottom of Bracket 2 (Short End) .
4. Use (3) ST4*35 Screws and fasten the
Mounting Bracket to the Wall in a
vertical orientation. Use the top hole
and the outside holes on the bottom.
5. Use Two (2) M5*12 Screws to install the
Mounting Bracket to the rear of the
Heater Body.
FOR YOUR SAFETY, READ ALL IMPORTANT INSTRUCTIONS (PAGE 7) AND USAGE (PAGE 13)
BEFORE USING YOUR PUREHEAT PATIO.
x2
x2
HEATER MUST BE MOUNTED HORIZONTALLY OR THE TIP OVER SAFETY SWITCH WILL ENGAGE
AND THE UNIT WILL NOT OPERATE.
Mounting Surface
Loading ...
Loading ...
Loading ...