Loading ...
Loading ...
Loading ...
Page 8
206-4065
M.P.I.
Antenna
Cable
Typical
TV Back
M.P.I.
Digital
Antenna
RF Coaxial Wire
(75ohm)
Antenna
RF Coaxial Wire
(75ohm)
Antenna
PILLOW SPEAKER
TV SPEAKER
VIDEO IN SPEAKER OUT
AUDIO IN
M.P.I.
Antenna
Cable
Typical
TV Back
M.P.I.
Digital
Antenna
RF Coaxial Wire
(75ohm)
Antenna
75 ohm
Signal Splitter
PILLOW SPEAKER
TV SPEAKER
VIDEO IN SPEAKER OUT
AUDIO IN
Hook Up an Off Air Antenna
1
2
Locate the Antenna/Cable
and Digital/Antenna jacks on
the back of the TV.
Connect the RF antenna
wires that run from the wall
directly to the jacks, accord-
ing to the connection dia-
gram shown to the right.
If you have a 75 ohm RF
cable, then you don’t need
any adapters!
A 300 to 75 ohm adapter is
not included with the Zenith
TV.
Over-the-Air Antenna
To get digital with only one RF antenna lead, install a 2- way signal splitter
Mini Glossary
2-Way Splitter A device that provides two antenna signals from one antenna lead.
75 ohm The wire that comes from an off-air antenna or cable service provider. Each end
RF Cable looks like a hex shaped nut with a wire sticking through the middle, and it screws
onto the threaded jack on the back of the TV.
300 to (Not shown) A small device that connects a flat two-wire 300 ohm antenna to a 75
75 ohm ohm RF jack. They are usually about an inch long with two screws on one end and a
Adapter round opening with a wire sticking out on the other end.
1
2
If there is only one antenna lead
available from the wall antenna
jack, locate the Antenna/Cable
and the Digital/Antenna jacks on
the back of the TV.
Connect the antenna that runs
from the wall directly to a 75
ohm 2-way signal splitter (not
provided) according to the con-
nection diagram shown to the
right.
Connect the two antenna leads
to the TV RF inputs:
Antenna/Cable and Digital
/Antenna. This will provide the
same over-the-air signal to both
the analog and digital RF inputs.
3
Connect an over the air signal source to the TV
Loading ...
Loading ...
Loading ...