Loading ...
Loading ...
Loading ...
Page 5 • JL Audio, Inc., 2017 Continued on Next Page
STEP 16
Replace the jack tools, if desired, and fold the
rear seats back down.
STEP 15
Slide a 1/4” Split Lock Washer and a 1/4” Flat
Washer over a 1/4 - 20 x 1” Hex Bolt, pass the
assembly through the slot in a Short Bracket,
into a threaded insert on the front of the
enclosure, and fully tighten.
Repeat the process for the opposite side.
STEP 14
Align the slot in each of the Long Brackets with
the threaded studs, as shown. Add a factory
nut over each threaded stud, and fully tighten.
STEP 13
Connect speaker cable to the terminal cup
on the side of the enclosure, and place the
Stealthbox into position, as shown. Route the
speaker cable as necessary.
STEP 12
Note the location of the threaded studs in the
back of the vehicle. Push the carpet down,
leaving the threaded studs exposed.
ST E P 11
Slide a 1/4” Split Lock Washer and a 1/4” Flat
Washer over a 1/4 - 20 x 1” Hex Bolt, and pass
the assembly through the short end of a Long
Bracket, and into a threaded insert on the back
of the enclosure.
Align the Long Bracket as shown, and fully
tighten.
Repeat the process for the opposite side.
STEP 10
Fold the carpet up, reinstall the Short Bracket
and Torx bolt, and fully tighten.
Repeat Steps 8-10 for the opposite side.
STEP 9
Remove the Short Bracket and Torx bolt.
Carefully cut a slit in the carpet on each of the
marks made in the previous step to allow the
carpet to fold up.
SB-GM-COCREW2G/10TW3 INSTR_SKU# 011474
Loading ...