Loading ...
Loading ...
Loading ...
13
A
B
C
D
E
Operation
m WARNING: Open lid during ignition.
m WARNING: Do not lean over open barbecue
while igniting or cooking.
m WARNING: If ignition does not occur within
four seconds of attempting to light the first
burner, turn the burner control knob to
the o position. Wait five minutes to allow
accumulated gas to dissipate, and then repeat
the lighting procedure.
Igniting the Barbecue
Using the Crossover Ignition System to
Ignite the Barbecue
The crossover ignition system ignites burner 1
furthest to the left with a spark from the igniter
electrode. You generate the energy for the spark by
pushing the igniter button. You will hear the igniter
clicking. Burner(s) 2 (and 3) can be lit after burner1 is
lit. All burners should be lit for preheating, however, all
burners do not have to be lit while barbecuing.
1) Open the barbecue lid (A).
2) Check that all burner control knobs are in the
o
position. Check by pushing in and turning
knobs clockwise (B).
Note: It is important that all burner control knobs are
in the o position before turning on the cylinder.
3) Turn gas supply on by turning cylinder valve
anti-clockwise (C).
4) Begin with burner 1 furthest to the left. Push the
burner control knob in and turn it counterclockwise
to the start/high
position (D).
IMPORTANT: Always ignite burner 1 first.
Theother burner(s) ignite from burner 1.
5) Push and hold the electronic ignition button (E).
Youwill hear it ticking.
6) Check that burner 1 is lit by looking through
the cooking grills and through the cutout in the
FLAVORIZER BARS.
7) If the burner does not ignite, turn burner control
knob to the o
position and wait five minutes to
allow the gas to clear before attempting to light the
burner again.
8) When burner 1 ignites, you can turn on burner 2
(and burner 3).
Should the burners fail to ignite using the electronic
ignition, refer to the TROUBLESHOOTING section.
Thereyou will find instructions on igniting the
barbecue with a match to help determine the exact
problem.
To Extinguish Burners
1) Push each burner control knob in and then turn
clockwise all the way to the o position.
2) Turn gas supply o at the cylinder.
A
B
D
E
C
Loading ...
Loading ...
Loading ...