BodyCraft SPR Indoor Club Group Cycle

User Manual - Page 2

For SPR.

PDF File Manual, 2 pages, Read Online | Download pdf file

SPR photo
Loading ...
Computer Specifications
Time counting up: 00:00:00 ~ 99:59:59
Time counting down: 00:05:00 ~ 99:59:00
Speed: 0.0 ~ 999.9 MPH or KPM
RPM: 15 ~ 999
Distance counting up: 0.0 ~ 999.9
Distance counting down: 1.0 ~ 999.0 Mile or Km
Calorie: 0.0 ~ 9999 K/Cal
Pulse*:
40 ~ 200 BPM. No Pulse displays "P"
Level: 1 ~ 16
Watt: 0 ~ 999
Working temperatures: 0°C ~ 50°C / 32°F ~ 122°F
Storage Temperatures: 0° ~ 60°C / 14°F ~ 140°F
*Polar® compatible 5kHz heart rate belt required. Not included.
Low-Battery Indicator
When the Battery starts to get low, the Low Battery symbol will appear in the upper
left hand corner of the display. When the battery icon begins to blink, it is important
to replace the battery or the computer monitor may not function properly.
Battery Replacement
The Indoor cycle computer is powered by 2 replaceable C-size (LR14) Batteries. They are NOT located
is the display itself, but behind a removable compartment by the Front Stabilizer as shown below.
1. Using a 5mm Allen wrench (originally included with
the bike) Unscrew the bolt counter clockwise and remove.
You will now be able to remove the Battery Cover.
2. Replace the 2-C size batteries. (NOTE: there may be a
tie wrap holding the batteries in place. Please cut and
discard. It does not need to be replaced and was only
used to secure the original batteries for shipment.)
3. Replace Battery Cover and reinstall screw with 5mm
allen wrench.
Resistance Calibration
You may find the need to recalibrate the Resistance Level Meter to the Resistance Lever.
Please follow this procedure if the Level will not lower to 1 or go up to 16.
1. Press the [UP] and [ENTER/RESET] simultaneously for 5 seconds to begin calibration process.
2. The Computer should display "LEVEL 1". Pull the Resistance Lever back completely to the lightest
resistance, then press [ENTER/RESET] to lock in the level 1 value.
3. The computer should now display "LEVEL 16". Push the Resistance Lever all the way forward to the
highest resistance and press the [ENTER/RESET] key to lock in the value.
4. The display will have returned to it's normal state. If the computer displays "LEVEL --" and beeps for
5 seconds, this means that the calibration has failed. Please repeat the above steps 1, 2 and 3 again.
If it fails again, replace batteries. If batteries do not resolve the issue contact you Bodycraft service
representative. Email: service@bodycraft.com