Loading ...
Loading ...
Loading ...
Tire Puncture u Removing Wheels
87
continued
Troubleshooting
Wheel Installation (VT750C)
Before installing the wheel, check that the
wheel hub and final drive gear splines are
coated with molybdenum disulfide paste.
1.
Position the wheel between the swingarm
and the final drive gear case.
u Be sure the splines on the wheel hub fit
into the final drive gear case.
2.
Install the side collar into the brake panel.
3.
Insert the rear axle shaft from the right
side, through the right swingarm, brake
panel, wheel hub and final drive gear
case.
4.
Reassemble the brake stopper arm.
Tighten the stopper arm nut.
5.
Connect the brake rod to the brake arm.
6.
Adjust the rear brake pedal freeplay.
2
P. 62
7.
Tighten the rear axle nut.
8.
Tighten the axle holding bolt.
9.
After installing the wheel, apply the brake
pedal several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
Recommended molybdenum disulfide
paste:
(USA only) Pro Honda Moly 60 Paste or
equivalent
Torque: 16 lbf·ft (22 N·m, 2.2 kgf·m).
Torque: 65 lbf·ft (88 N·m, 9.0 kgf·m).
Torque: 20 lbf·ft (27 N·m, 2.8 kgf·m).
Loading ...
Loading ...
Loading ...