Loading ...
Loading ...
Loading ...
Using The Steam Cleaner
13
Using The Steam Cleaner
• Always drain condensed water from Hose before use or if appliance
has been left idle for a period of time. To drain, direct steam gun
opening into a sink and slide Steam Control trigger on Steam Gun
forward. Once Hose is empty, resume normal use. Never direct the
steam jet toward people, animals or plants.
• Extreme care should be taken when opening the Boiler Cap as it
may become hot during use and escaping steam can cause scalding.
CAUTIONS
4
Turning Steam Cleaner ON
• Plug electrical cord into a power outlet.
• Press the Power Switch.
• The Power indicator light (orange) will turn on.
• TheSteamCleanerwillheatupinapproximately6-7minutes.
• When the green Steam Ready Light illuminates, the Steam Cleaner is
ready to use.
• Some water may come out from the steam gun on the attachments.
This is unheated, condensed water in the Hose and is normal.
Steam Release
To release steam from the Steam Cleaner,
slide forward the steam control trigger
found on the Steam Gun. Steam will
continue to be released while the trigger is
in the forward position. To stop the steam,
slide the steam control trigger backward.
5
NOTE: Do not turn on Steam Cleaner if Water Tank is empty.
IMPORTANT: When the Steam Cleaner has run out of
water,steamoutputwillcease.Followrellinstructionsto
use your Steam Cleaner again.
6
Relling the Boiler During Use
• ALWAYS vent the Boiler (release all pressure/steam) before
opening Boiler Cap. Venting is done by sliding the Steam Control
Trigger forward to the “On” position. If no steam is emitting then
there is no pressure in the Boiler and the Boiler Cap is safe to
open. Slide back the Steam Control Trigger to the “Off” position.
• Always unplug the unit and be sure it has cooled off before re-
llingtheBoiler–atleast5minutes.
• NEVER turn on Steam Cleaner if the Boiler is empty!
WARNINGS
Loading ...
Loading ...
Loading ...