Loading ...
Loading ...
Loading ...
subzero.com | 17
Completion
TOP TRIM INSTALLATION
Identify the top trim strips by the notch on one end at the
bottom; this trim strip ts on the hinge side of the unit.
Insert the outer end of each trim strip behind the vertical
side trim. Engage the snap in the plastic side bracket and
slide the panel as far to the outside as possible. Refer to the
illustration below.
Rotate the inner end of each panel into the side ange of
the center shroud next to the water lter access door. Press
on the trim strip to snap into place. Refer to the illustration
below.
Inner top trim
Outer top trim
INSTALLATION
KICKPLATE INSTALLATION
Position the kickplate and install using the two mounting
screws. Refer to the illustration below. The kickplate must
be removable for service. The oor cannot interfere with
removal.
For indoor models, a maximum 6"
(152) decorative kickplate
can be attached to the factory-installed kickplate. The two
rows of vented louvers can be covered if the door panel is a
minimum 4"
(102) from the nished oor. A decorative kick-
plate cannot be attached to the outdoor model.
To install a decorative kickplate, remove the paper backing
from the magnets and attach the decorative kickplate to the
magnets. The magnets allow the decorative kickplate to be
removed if necessary.
Turn power on by touching “power” on the control panel.
SCREWMAGNET
Kickplate installation
Loading ...
Loading ...
Loading ...