Loading ...
Loading ...
Loading ...
CARE AND MAINTENANCE
• Checkthatthekettleisswitchedoffbyliftingthekettlefromthepowerbaseandreplacingit.
• Switchthepoweroffandremovetheplugfromthewallpoweroutlet.
• Allowthekettletocooldownfully.
• Wipeovertheoutsideofthekettleandpowerbasewithadampcloth.Amilddishwashing
detergent may be used if required.
• Keepallconnectorsandsocketsdry.
• Donotimmersethekettleorpowerbaseinliquid.
• Donotuseharshorabrasivecleaningagentsorsolvents.
• Cleantheinsideofthekettleusingtheinstructionsinthe“DE-SCALEREGULARLY”section.
DE-SCALE REGULARLY – EVEN IN SOFT WATER AREAS
Water contains minerals that will form deposits on the inside of your kettle, commonly referred
to as scaling. Scaling discolours the internal surfaces and can affect the performance.
To maintain the performance of your kettle, it should be de-scaled every three months or so.
De-scale more frequently if you live in a hard water area.
• Add2to3teaspoonsofcitricacidoracommercialde-scalertotheemptykettle.
• FillthekettlewithfreshcoldwatertotheMAXlevelmarkonthewatergauge.
• Switch the ON/OFF switch to ON and allow the kettle to boil.
• Once the water has boiled allow the kettle to cool.
• Once the kettle has cooled, discard the water into the sink.
RINSE AFTER DE-SCALING
• FillthekettlewithfreshcoldwatertotheMAXlevelmarkonthewatergauge.
• Switch the ON/OFF switch to ON and allow the kettle to boil.
• Discard the water into the sink.
• Repeattherinsingprocess3times,discardingthewaterinthekettleeachtime.
NOTE: Products returned under warranty with faults due to scale may be subject to a repair charge.
WATER FILTER
Scale particles suspended in the water may give it a cloudy or greasy appearance. The filter will
prevent these particles going into your drink. Remove and clean the filter regularly.
CLEANING THE FILTER
• Checkyourhandsarefreefromsoap,handcream,oranythingwhichmightleaveataint.
• Switchthepoweroffandremovetheplugfromthewallpoweroutlet.
• Allowthekettletocooldownfully.
• Removethelid.
• Pullthelterupandoutofitshousing.
NOTE: Take care not to press on the mesh part of the filter – you may damage it.
• Rinsethelterunderarunningtapwhilstbrushingwithasoftbrush.
• Rinsethekettleincasescaleparticleshavefalleninside.
• Turntheltersothetabatthetopofthelterfacestherearofthekettle.
• Slideitdownintotheguidesinthelterhousing.Ensureitisrmlyinplace.
• Rellthekettleandreplacethelid.
Caution: Do not use the kettle without the filter in place – it may spit boiling water.
Montana Kettle
RussellHobbsMontanaKettlereducesthenoiseemittedfromyourboilingkettle.Asyouusethe
kettle, scale will deposit on the base of the kettle, slowly decreasing the effect of noise reduction.
Regularde-scalingwillkeepyourkettlecleanandquiet.
Loading ...
Loading ...