3090 User Manual

Loading ...

BEFORE USING FOR THE FIRST TIME

Fill the kettle with water to the ‘max’ level, boil, discard the water, and then rinse. Do this three times,

to remove any dust, residues, etc., from the kettle.

• Ensurethelterisinplace;otherwisethekettlemaynotswitchoffandmayspitwater

from the spout.

POSITIONING

• Placethepowerbaseonastable,levelsurface.

• Routethecablesoitdoesnotoverhang,andcannotbecaughtortrippedover.

• Windexcesscablebeneaththepowerbase.

FILLING

Caution: If the kettle has just boiled it will be full of steam. Keep hands clear as steam will

escape from the kettle when opening the lid.

• Removethekettlefromthepowerbase.

• Graspthelidknobandthenliftthelidupandawayfromthekettletoavoidsteamfromreaching

your hand.

• Fillthekettlewithatleast2cupsofwater.

• Donotllabovethe‘max’line.Ifoverlled,thekettlemayspitboilingwater.

• Replacethelidbackonthekittle.

• Checkthelidisfullyclosedorthekettlemaynotswitchoffwhenitboils.

SWITCHING ON

Caution: Keep clear, as steam will escape from the spout when boiling.

• Plugthepowercordintothewallpoweroutletandswitchiton.

• Placethekettleonthepowerbase–takecarenottospillanywater.

• Presstheboilswitchdown–theboilswitchwillilluminateandthekettlewillheatup.

SWITCHING OFF

• Whenthewaterboils,thekettlewillswitchitselfoff.

• Toswitchoffmanually,lifttheboilswitchorliftthekettlefromthepowerbaseandreplaceit.

The boil switch will pop up.

GENERAL

• Removethekettlefromthepowerbasebeforepouring.

• Toavoidtheriskofsplashing,pourslowlyanddonotover-tiltthekettle.

• Donottiltthekettlebackwardsaswatermightgetintothecontrolarea.

• Ifthishappens,emptyanyremainingwaterandallowthekettledrybeforefurtheruse–sitit

somewherewarmfor12hours.

• Whenyouliftthekettle,youmayseemoistureonthepowerbase.Thisisthesteamusedto

switch the kettle off automatically, which then condenses and escapes via vents under the

kettle. This is normal.

USING WITH INSUFFICIENT WATER

• Usingthekettlewithinsufcientwaterwillshortenthelifeoftheelement.

• Ifthekettleisaccidentlyswitchedonwhenitdoesnotcontainsufcientwater,aboil-dry

cut-outwillswitchthekettleoff.

• Topreventthekettlecyclingonandoff,removeitfromthepowerbaseandtheboilswitch

will pop up.

• Sitthekettleonastableheatresistantsurfaceuntilithasfullycooleddown.

• Donotllthekettlewithwateruntilitiscold,oritmayspit.

Loading ...

User Manual - Page 5