Loading ...
Loading ...
Loading ...
Operating the appliance en
27
Here’s how to change the setting:
1. Switch on ON/OFF switch (.
2. Hold down the programme button
# and then repeatedly press the
START button ` until •:‹...
appears in the display window.
3. Release both buttons.
The LED of the # button flashes
and the display h shows the
factory setting •:‹….
4. Press the programme button #
repeatedly until the factory setting
value ™:‹‹ appears in the display
window h.
5. Press the 3 button to switch the
child-proof lock on ™:‹‚ or off ™:‹‹.
6. Press START button `.
The set value is saved.
Switching on the appliance
1. Turn tap fully on.
2. Switch on ON/OFF switch (.
The Eco 50° programme has been
preset for environmentally friendly
operation whenever the appliance
starts. This programme remains
selected if no other programme
button 0 is pressed.
3. Press START button `.
Programme sequence starts.
Note:
For ecological reasons the Eco 50°
programme is preset whenever the
appliance starts. This conserves
environmental resources and not least
saves you money.
The Eco 50° program is a particularly
environmentally friendly program and
well-suited for normally soiled
tableware. It is the most efficient
program in the combination of energy
and water consumption for this type of
conformity with the tableware and
content of the EU European Ecodesign
Directive.
timeLight
(optical display while a
programme is running) *
ti meLi ght
* depending on the configuration of
your specific dishwasher
While a programme is running, an
optical display (additional programme
information) is projected onto the floor
at the bottom of the appliance door. If
the base panel is pulled forwards or if
the appliance is installed at eye-level
flush with the furniture then this display
will not be visible.
Possible settings of the optical
display:
The setting †:‹‚ is set up at the factory.
Here’s how to change the setting:
1. Switch on ON/OFF switch (.
2. Hold down the programme button
# and then hold the START button
` until •:‹... appears in the
display window h.
3. Release both buttons.
The illuminated display on the button
# flashes.
4. Press the programme button #
repeatedly until †:‹... appears in the
display window h. (for the optical
display) together with the previously
set value, for example †:‹‚.
5. Press the programme button 3
repeatedly until the desired value, for
example †:‹‹, appears in the
display window h.
6. Press START button `.
The set value is saved.
†:‹‹ The display is switched off.
†:‹‚ /
†:‹ƒ
The display can show the
programme, the timed delay,
remaining time and end of the
programme.
Loading ...
Loading ...
Loading ...