Loading ...
Loading ...
Loading ...
15
Problem Possible Causes Solutions
The machine won't operate. The icemaker is unplugged.
The icemaker power switch is
OFF.
The ice storage bin is full of
ice.
Plug the ice maker in.
Turn the ice maker power switch to ICE
(ON)
Take away some ice cubes; make the ice
full probe is free of ice.
The compressor works ab-
normally with a buzzing
noise
The voltage is lower than rec-
ommended
Stop the ice maker and do not restart until
the voltage is normal
The water doesn't feed in
after the ice maker starts.
The water supply tap is turned
off.
The water supply pipe is not
proper connected.
Turn on the water supply tap.
Reconnect the water supply pipe.
Machine makes ice, but bin
does not fill up with ice
The condenser may be dirty.
The air flow to the ice maker
may be obstructed.
The ambient temperature and
water temperature are high, or
it is near with some heat
source.
Clean the condenser.
Check the installation.
Run the unit for longer period of time.
Water is leaking out the
unit.
A few water droplets are on
the door.
The water supply connection
is leaking.
Under some conditions, humidity may con-
dense on the door. Consider moving the
unit or just be more careful when you open
the door.
Tighten water supply hose fitting.
Cubes are partially formed -
-are white at the bottom.
Not enough water in the water
bin.
Check if the water supply pressure is be-
low 15 psi.
Check water supply — may be restricted.
Check for a water leak at the water trough.
Noise during operation The feet are not leveled and
locked.
Certain sounds are normal.
Level the feet. See Leveling the ice maker.
See Normal Sounds.
The ice made is too large
and with pieces sticking
together
The water temperature in the
storage tray or ambient is too
low
Stop the machine and reset the ice
making cycle
Restart the machine after
turning it off
Conditions for ice making
cycle are right but no ice is
made
Refrigerant leaks/ sealed sys-
tem is blocked
Water pressure is not properly
set
Contact Whynter Service Department
The recommended water pressure is 58
PSI. - 15 psi and a static pressure not to
exceed 80 psi
The icemaker stops sud-
denly while making ice.
The electricity is off.
The room temperature is out
of the stated range.
Reconnect the power supply line.
Cut off the electricity and let the ice maker
stop working until the temperature returns
within the stated range.
The body of the ice maker
is electrified
The ground line isn't in the
socket.
Use the correct plug and outlet.
Scale builds up quickly in-
side the machine.
The calcium level in the water
is too high.
Use a water softening apparatus installed
in front of the water inlet valve.
TROUBLESHOOTING
Loading ...