Loading ...
Loading ...
Loading ...
9
REHANG THE FREEZER DOOR
Transfer the
screw cover on
top of the door to
the opposite side.
Make sure the
washer (if applicable) is in place on the center hinge pin.
Place the freezer door on the center hinge over the pin.
Assure the door is aligned horizontally and vertically,
and that the gasket seals on all sides.
Attach the top hinge removed earlier on the left side of
your refrigerator and replace the hinge cover
7
TRANSFER TOP HINGE TO THE LEFT
Using a putty knife with the edge covered with
masking tape, remove the screw cover on the left.
Be careful of the
paint finish.
Reinstall the screw
cover on the right
side.
REVERSING THE DOOR SWING (CONT.)
Installation Instructions
11
4
TRANSFER FRESH FOOD DOOR STOP
TO THE LEFT
Remove the door stop and hinge pin sleeve from the
bottom of the right side of the door.
Using the left door stop included with the parts that
came with your
refrigerator, transfer
the hinge pin sleeve
to the left side and
install the left door
stop.
5
REHANG THE FRESH FOOD DOOR
Make sure the washer(s)
are in place on the bottom
hinge pin. Make sure the
door is aligned horizontally
and vertically. Place the
fresh food door on the
bottom hinge, close the
door and tape it in place
with masking tape.
Remove the screw
covers from the left
edge of the door and
insert it into the hole
on the opposite side.
6
I
NSTALL CENTER HINGE ON THE LEFT
Remove the three screw
covers on the left side and
install two of them on the
right.
Using the middle hinge
with shim and screws
(and washers if applicable)
removed earlier, install the
middle hinge on the left side.
Remove the tape holding the
door shut.
NOTICE: When assembled
correctly, the hinge is tight
against the cabinet.
ATTENTION: The screws must be properly tightened.
Turn the screws until snug. Then tighten the screws a
minimum of 1/2 turn using both hands.
Screw Covers
Screw Cover
8
TRANSFER FREEZER DOOR STOP TO
THE LEFT
Remove the door stop and
hinge pin sleeve from the
bottom of the right side of
the door.
Using the left door stop
included with the parts that
came with your refrigerator,
transfer the hinge pin sleeve to the left side and
install the left door stop.
Loading ...
Loading ...
Loading ...