Loading ...
Loading ...
Loading ...
INSTALLATION
TECHNICAL INFORMATION FOR THE
INSTALLER
Installation, adjustments of controls and
maintenance must only be carried out by a
qualified engineer.
The appliance must be correctly installed in
conformity with current law and the
manufacturer's instructions.
Incorrect installation may cause damage to
persons, animals or property for which the
Manufacturer shall not be considered
responsible.
During the life of the system, the automatic
safety or regulating devices on the appliance
may only be modified by the manufacturer or by
his duly authorized dealer.
3)
INSTALLING THE HOB
Check that the appliance is in a good condition after
having removed the outer packaging and internal
wrappings from around the various loose parts. In
case of doubt, do not use the appliance and contact
qualified personnel.
Never leave the packaging materials (cardboard,
bags, polystyrene foam, nails, etc.) within
children’s reach since they could become
potential sources of danger.
The measurements of the opening made in the
top of the modular cabinet and into which the ho
b
will be installed are indicated in either fig. 7. Always
comply with the measurements given for the hole
into which the appliance will be recessed (see
fig. 7 and 8).
The appliance belongs to class 3 and is
therefore subject to all the provisions
established by the provisions governing such
appliances.
4)
FIXING THE HOB
The hob has a special seal which prevents liquid
from getting into the cabinet. Strictly comply with
the following instructions in order to correctly
apply this seal:
- Detach the seals from their backing, checking that
the transparent protection still adheres to the seal
itself.
- Overturn the hob and correctly position seal
“E” (fig. 9) under the edge of the hob itself, so that
the outer side of the seal perfectly matches the
outer edge of the hob. The ends of the strips
must fit together without overlapping.
- Evenly and securely fix the seal to the hob,
pressing into place with the fingers and remove
the strip of protective paper from the
seal and
set the hob into the hole made in the cabinet.
- Fix the hob with the proper brackets “S” and fit the
prominent part into the porthole “H” on the bottom;
turn the screw “F” until the bracket “S” stick on the
top (fig. 10).
- IMPORTANT: When not installing above an oven,
underneath the appliance there must be a partition
made of insulating material (e.g. wood). There must
be a gap of at least 70 mm between the underneath of
the appliance and this partition (fig. 7.).
FIG. 7 FIG. 8 FIG. 9
FIG. 10
COMPLY WITH THE DIMENSIONS
(mm)
6
IMPORTANT: A perfect installation,
adjustment or transformation of the hob to
use other gases requires a QUALIFIED
GASSAFE I NSTALLER: a failure to follow
this rule will void the warranty.
A B C D E
2F 280 482 59 59 100 min.
Loading ...
Loading ...
Loading ...