Loading ...
Loading ...
Loading ...
subzero.com | 7
Installation
INSTALL ICE MAKER
1 Adjust the leveling legs close to the desired height. Refer
to the illustration below.
2 Reverse the door swing if needed. Refer to steps out-
lined on page 9.
3 Gravity Drain Model: Install the drain hose provided onto
the drain tting on the back of unit and route to the open
site drain. Refer to the illustration below and plumbing
requirements on the previous page.
Drain Pump Model: Route the drain tubing through the
drain tting on the back of the unit and install the drain
hose provided on the drain pump. Route the other end of
the drain tubing to the drain site. Refer to the illustration
below and plumbing requirements on the previous page.
4 Use a compression tting to connect the water inlet on
the back of ice maker to the prepared
1
/4" (6) OD cold
water line. Refer to the illustration below.
5 Open the shut-off valve on the water line. Check all
plumbing connections for leaks. Failure to do so could
result in ooding.
6 Plug the power cord into the grounded receptacle.
7 Level the ice maker to assure the door closes and seals
properly. Place a level on the top of the unit and turn
each leveling leg to raise or lower as needed.
8 Move the ice maker into its nal position.
9 Anchor the ice maker by installing the two at head
screws provided through each hinge. Refer to the illus-
tration below.
INSTALLATION
ANCHORING
SCREWS
Anchoring
LEVELING
LEG
WATER INLET
DRAIN FITTING
Leveling
Drain connection
Loading ...
Loading ...
Loading ...