Loading ...
Loading ...
Loading ...
10 | Sub-Zero Customer Care 800.222.7820
INSTALLATION
Custom Panel
OVERLAY PANEL
For overlay applications, a custom door panel must be
installed. The panel size is critical for a proper ๎t. To verify
panel requirements and dimensions, refer to the Sub-Zero
Design Guide at subzero.com/specs.
Finish all sides of the custom panel. They will be visible
when the door is open.
A D-style handle is recommended. The door handle must be
located near the edge of the panel opposite the hinge, cen-
tered top to bottom. Stainless steel tubular and pro handles
are avail able through an authorized Sub-Zero dealer. For
local dealer information, visit the ๎nd a showroom section
of our website, subzero.com.
PANEL INSTALLATION
Remove the handle side bracket attached to the front of
the door. Place the custom door panel face down on a
protected work surface. Place the template on the back of
the door panel, then mark and drill the holes. Secure the
mounting bracket to the panel with the #8 x
1
/2" screws
provided. Refer to the illustration below.
Install the door panel by engaging the tabbed bracket to
the door. Once the door panel is in place, use the remaining
#8 x
1
/2" screws to secure the panel to the upper and lower
mounting brackets. Once secure, install the hinge covers.
Refer to page 11.
UPPER
BRACKET
LOWER
BRACKET
Template position
Mounting brackets
Loading ...
Loading ...
Loading ...