Loading ...
Loading ...
Loading ...
SAFETY FEATURES
The UberHeat
TM
Ceramic Heater is equipped with several devices and features for added protection:
• A four way tip-over switch disables the heater if it is accidentally tipped in any direction.
If tipped over, the unit should be set upright and follow the OPERATION instructions.
• A high temperature safety control prevents overheating. If activated, unplug the device and wait
at least 10 minutes or allow the unit to cool completely. Then plug the heater back in and follow
the OPERATION instructions.
• The heater is also equipped with a thermal cut-off fuse that will permanently shut down the
heater should it operate at a higher than normal temperature. If activated, the unit will need
to be replaced.
• This heater was created using a high quality, heat resistant plastic and has a Cool to Touch housing.
CLEANING
We recommend that the UberHeat
TM
Ceramic Heater be cleaned at least once a month and before
off-season storage.
• Turn the heater OFF and unplug it. Allow it to cool.
• Use a dry cloth only to clean the external surfaces of the heater. DO NOT USE WATER, WAXES,
POLISHES OR ANY CHEMICAL SOLUTION.
STORAGE
• Clean your UberHeat
TM
Ceramic Heater using the above-mentioned steps. Wrap the cord around
the unit. Place in its original box and store it in a cool, dry place.
• This heater does not disassemble.
• Turn the Thermostat Control fully clockwise to the highest setting.
• When the room reaches a comfortable temperature, slowly turn the Thermostat Control
counter-clockwise until the heating element goes off (the red Power Light will not be shut
off). This is the point at which the Thermostat setting equals the room temperature. At this
setting, the Thermostat will automatically turn the heater on and off to maintain the selected
temperature.
• Turn the Power Switch to OFF ( ) and unplug the heater when you are finished using it.
OPERATION (CONTINUED)
4
Loading ...
Loading ...
Loading ...