Loading ...
Loading ...
Loading ...
15
WARNING:
Always be sure of your footing
on slopes. Operation on slopes requires extra
caution. If you feel uneasy on a slope, do not
mow it.
DO:
- Mow across the face of slopes; never mow
up and down. Exercise extreme caution when
changing direction on slopes.
- Watch for holes, ruts, rocks, hidden objects,
or bumps which can cause you to slip or trip.
Tall grass can hide obstacles.
DO NOT:
- Do not mow near drop-os, ditches or
embankments; you could lose your footing or
balance.
- Do not mow slopes greater than 15 degrees.
- Do not mow on wet grass. Unstable footing
could cause slipping.
Mower overload protection
To prevent overload conditions, do not try to
remove too much grass at one time. Slow down
your cutting pace or raise the cut height. Your
mower has built-in overload circuit protection.
When the mower is overloaded, the motor will
shut down.
Check to see if grass has collected beneath the
deck and clean it if necessary, then restart the
mower.
Battery high temperature protection
The battery pack will generate heat during
operation. The heat dissipates more slowly in hot
weather. If the battery temperature exceeds more
than 158
˚
F during operation, the protection circuit
will immediately shut down the mower to protect
the battery pack to avoid any damages. Release
the bail handle, wait until the battery pack cools
down, then restart the mower.
Emptying the grass bag
When the grass bag full indicator start to trail
during cutting grass, it is time to empty the grass
bag.
NOTE:
Before taking o the grass bag, switch
OFF the power and wait until the blade has come
to a stop.
1. To take o the grass bag, use one hand to lift
up rear ap and the other hand to grab onto
the carry handle. The rear ap automatically
falls down after removed the grass bag.
2. Empty the grass debris in the grass bag, and
attach grass bag back to the mower.
NOTE:
If any grass residue is caught in the
discharge chute, clean it using a brush. Do not
remove grass debris in the mower chassis or
on the blade by hand or your feet. Instead use
suitable tools such as a brush or broom. To
ensure that the cut grass can be collected into
grass bag, the discharge opening and inside the
mower chassis must be cleaned of any blockage.
Charging the battery pack
NOTE:
Remove the battery pack from the
charger after it has been fully charged.
NOTE:
Battery should be fully charged before
rst use.
NOTE:
Make sure the mains voltage is the same
as rating label which is located on the charger.
Connect the charger to a power supply. The red
LED will light up.
1. To insert the battery pack into the charger,
align the raised ribs of the battery pack with
the grooves of the charger then push it in.
(See Fig. 20)
2. The green LED light of the charger will ash
continuously during normal charging.
3. After charging is complete, the green LED
will light up.
Power indicator (Fig. 21)
This Li-Ion battery pack is equipped with a power
indicator which is used to show the battery pack’s
remaining charge. Press the power indicator
button to check battery charge as below. The
LEDs will stay lit for approximately 4 seconds.
To obtain the best life from the battery
1. Never allow the battery to completely
discharge before recharging. The battery
pack should be placed on the charger
whenever the battery pack is noticeably
running down or the tool no longer performs
a task it previously performed.
2. Avoid conducting short charges. Make sure
that the battery is fully charged each time
by allowing the charger to complete its full
charging cycle.
3. Avoid allowing loose items like screws or
nails etc. to be stored with battery packs as
these or similar items can short battery packs
Loading ...
Loading ...
Loading ...