Loading ...
Loading ...
Loading ...
11
REMOVE DUCT KNOCKOUT(S)
If recirculating, non-vented ductless (optional for
JV5 Series models only), see note below and skip to
Step 9 D and proceed. The JV6 Series models cannot
be recirculated.
Using a flat blade screwdriver, remove the appropriate
duct knockout(s) from the top or back of the hood.
3¼” x 10” Rectangular
vertical discharge.
Remove top rectangular
duct knockout only.
7
” Round vertical
discharge. Remove semi-
circular duct knockout and top
rectangular duct knockout.
3¼” x 10” Rectangular
horizontal discharge. Remove
rear rectangular duct knockout only.
FOR 3¼” x10” RECTANGULAR
DUCTED DISCHARGE
INSTALLATIONS ONLY:
Attach exhaust adaptor/damper over knockout
opening with two exhaust adaptor screws. Make sure
damper pivot is nearest to top/back edge of hood.
Remove tape from damper flap.
Up to 1” side-to-
side adjustment
Tape
Top/back edge
Exhaust adaptor/damper
(vertical discharge position
shown)
Pivot
FOR 7” ROUND VERTICAL
DUCTED DISCHARGE
INSTALLATIONS ONLY:
Re-install the 7” round exhaust adaptor with its
screws, removed in Step 2 under the “Prepare the
Hood” section.
7
8
7” round
exhaust
adaptor
NOTE: The 7” round exhaust adaptor can be installed
up to 1 inch on either side of the hood center to
accommodate off-center ductwork. In extreme off-center
installations, one end of the duct connector may need
to be trimmed to clear the electrical cable clamp.
NOTE: The 7” round damper is not included with
this product. It can be purchased as a kit by calling
1.800.661.1616. Order kit number JXDA22.
Installation Instructions
NOTE: The exhaust adaptor/damper can be installed
up to 1 inch on either side of the hood center to
accommodate off-center ductwork. In extreme off-
center installations, one end of the duct connector may
need to be trimmed to clear the electrical cable clamp.
NOTE: If the hood is to be installed in a recirculating,
non-vented ductless manner, order charcoal filters,
kit number WB02X11000 for 30
” hood models, or
kit number WB02X11001 for 36
” hood models.
These kits can be ordered from your GE supplier.
Skip to Step 9 D and proceed.
6
1 Ft = 0.3 m
1” = 2.5 cm
Loading ...
Loading ...
Loading ...