Loading ...
2
Install new receiver logic board (continued)
3
3.3 Connect the wire harnesses to the
new receiver logic board. When
reconnecting the wire harness, be sure
the tabs on the wire harness are facing
the end panel, not the logic board.
NOTE: A test of the safety reverse system is necessary for safe operation.
Learn
Indicator Light
Yellow Learn
Button
1
Programming
1.1 Press and release the Learn button on the garage door opener. The Learn indicator light will
glow steadily for 30 seconds.
1.2 Within 30 seconds, press and hold the
button on the remote control.
1.3 Release the button when the garage door
opener light blinks. It has learned the
code. If light bulbs are not installed, two
clicks will be heard.
Program a remote control using the learn button
3.5 Reinsert the wires.
Door control wires:
• white wire into the white terminal.
• white/red wire into the red terminal.
Safety sensor wires:
• white wires into the white terminal.
• white/black wires into the
grey terminal.
To insert or remove the
wires from the terminal,
push in the tab with a
screwdriver tip.
Red
White
White
Grey
Logic Board
End
Panel
Wire
Harness
Tabs
3.4 Slide the tabs on the cover into the slots
on the end panel. Rotate the cover into
place and attach with 2 screws. Reinstall
the light lens. Reconnect power.
End panel
Tab
Cover
3.2 Reinstall the end panel. With the edge
of the end panel above the chassis,
rotate the end panel into place from the
top down. Snap the tabs into place and
connect with 2 screws.
Edge of End Panel Above Chassis
Tabs
NOTE: Ensure the antenna wire
is hanging straight down.
Loading ...
Loading ...
Loading ...