Loading ...
Loading ...
Loading ...
120v
LITHIUM-ION
TM
13
3. Select your required speed setting by
depressing the speed adjustment button.
4. Move your thumb away from the safety
button.
To switch OFF
- Release the on/o trigger switch. (ON/OFF
button)
NOTE:
Always switch o line trimmer before
placing it down.
Speed adjustment (See Fig. 9)
This line trimmer has 3 speed settings which can
be changed with a press of the button.
1. Ensure the line trimmer is switched ON.
2. Press the speed adjustment button and set to
your desired cutting speed.
3. If the speed is set to the highest speed, press
the speed adjust button again and this will
reduce to the lowest speed.
NOTE:
This trimmer also has the speed
memory function, with the battery pack was
kept in position. The speed setting of next
use can be kept the same as previous use.
To Increase Line Length
1. The line trimmer comes with a full line pool.
2. The line will wear in use and you will need to
feed out new line .
3. The cutting bump head allows the operator to
release more line without stopping the motor.
As line becomes frayed or worn, additional
line can be released by tapping the bump
knob on the ground while operating the
line trimmer.
NOTE:
For a good cutting performance. Cut high
grass in stages. Starting from the tip.
Special notice for line trimmer use
1. For best results, do not cut wet grass
because it tends to stick to the cutting head
and guard, prevents proper discharge of
grass trimmings, and could cause you to slip
and fall.
2. Pay special attention when performing the
work close to trees and bushes. The cutting
head could damage sensitive bark, and
damage fence posts.
Removing/replacing the cutting bump head
WARNING:
Before performing any
assembly, always ensure that the battery pack
has been removed.
If the nylon cutting line is broken and the nylon
spool needs replacing.
WARNING:
wearing working gloves when
doing any replacements.
Note!
Alway use Yard Force branded service
replacement parts - to prevent voiding your
warranty.
1. Line up the safety spacer hole up with the
hole on the side of guard. (See Fig. 10)
2. Place a small screw driver or metal rod in the
spacer hole. (See Fig. 11)
3. Rotate the head clockwise to loosen and
remove.
4. Reverse steps 1 - 3 to reinstall the same
cutting bump head.
5. Make sure that the cutting head is securely
located.
Removing /replacing old trimmer line
1. Press two release tabs simultaneously on the
cutting bump head and pull the spool cover
out. (See Fig.12)
2. Remove the spool from the spool retainer,
keep the spring in position. (See Fig.13).
Clean any remaining line, dirt and debris,
replace the spool if damaged.
3. Take approximately 16 ft. of 0.095” diameter
line and insert the midpoint into the slot
bottom in the central rim of the spool. (See
Fig.14 &15)
4. Wrap the line evenly and rmly around
the spool as per the arrowhead direction
(clockwise when tap button towards you) on
both grooves.
5. Position the lines in the guide slots with 3~5
inch line left.
6. Insert the ends of the lines through the line
exit holes in the side of spool container.
7. Place the spool back into the spool container,
make sure the spring is in position.
8. Reinstall the spool cover back and push it
until cover snaps into place.
Loading ...
Loading ...
Loading ...