Loading ...
Loading ...
Loading ...
63
15 INCH & 24 INCH INSTALL GUIDE
ANTI-VIBRATION
BUMPERS
WINE SHELVING ADJUSTMENT
The glide out wine shelves in TBC, TWC and TWZ-DZ
models consist of 3 pieces. These pieces are the wire
wine rack and 2 mounting bracket/glide assemblies
(one for the hinge side and one for the non-hinge side).
To remove the wine shelf, pull up on the front of the
wine rack and it will separate from the two mounting
brackets. The two mounting brackets may now be
removed from the pilasters by lifting straight up then
pulling the brackets out of the pilasters.
NOTE WHEN REINSTALLING THE BRACKETS,
THE BRACKET WITH THE LARGER VIBRATION
BUMPER MUST BE INSTALLED ON THE SAME
SIDE OF THE CABINET AS THE DOOR HINGE.
WHEN REINSTALLING THE WINE RACK, BE
SURE THAT THE BACK OF THE RACK HOOKS
UNDERNEATH THE TAB ON THE GLIDE.
The tab on the front of the glide must also fit securely
in the gap between the handle and the rack (see
illustration). If the fit is too tight, you may need to
loosen the screws on the back of the handle to increase
the gap.
The wine shelves are held securely by the anti-vibration
bumpers. If there is too much play side-to-side, tighten
the bumpers against the compartment walls by rotating
with your fingers.
GLASS SHELVING ADJUSTMENT
The glide out glass shelves are already attached
to the mounting bracket/glide assemblies.
To install the glass shelves insert mounting
brackets into pilasters.
To remove the glass shelves, simply lift straight
up then pull the brackets out of the pilasters.
Loading ...
Loading ...
Loading ...