Loading ...
Loading ...
Loading ...
DJI Goggles Racing Edition
User Manual
© 2019 DJI All Rights Reserved.
9
2. Power on the Goggles RE, swipe downward with two ngers on the touch panel to enter the
shortcut menu and select “Racing Drone (Analog)> Frequency Scanning” to search for the
frequency you need.
The analog frequency band is 5.650 GHz - 5.925 GHz, of which 5.725 GHz - 5.850 GHz
are ISM frequency bands. You may use these frequencies without permission but please
be sure to have the relevant license and follow local regulatory procedures when using the
other frequency bands.
The Pagoda antenna is an omnidirectional left hand circularly polarized (LHCP) antenna
design. It is recommended to use the Pagoda antenna or other left hand circularly
polarized antennas for analog transmitters to achieve the best transmission performance.
In a multi-aircraft ying environment, the adjacent frequency interval should be higher than
25 MHz to avoid nearby frequencies affecting the live view of your Goggles RE.
DJI OcuSync Air System
The Goggles RE's built-in DJI OcuSync dual-band wireless receiver is compatible with a DJI
OcuSync Air System, which you can install on a third-party device to transmit digital video signals.
Digital video transmission supports 1280 × 960p50, 1280 × 720p60 and 640 × 480p50, as well as
automatic Frequency-Hopping Spread Spectrum (FHSS) transmission. Digital video transmission
can also access to up to 19 selectable transmission channels, which can be used for racing drones,
model aircraft, ship, and other vehicles, as well as for industrial use.
Basic Linking
1. Install the Pagoda antenna (SMA interface) to Goggles RE’s SMA port.
2. Install the DJI OcuSync Air System on a third-party device to link with the Goggles RE. Please
refer to the illustration below to mount and connect the components onto your device.
3-in-1 Cable (Power, S.Bus, UART)
RED: Power (9-16.8 V) WHITE: UART RX (Connects to OSD TX, 0-3.3 V)
BLACK: Power GND GRAY: UART TX (Connects to OSD RX, 0-3.3 V)
BROWN: Signal GND YELLOW: S.Bus (Connects to Flight Controller RX, 0-3.3 V)
DJI OcuSync Camera
Devices that support PPM
signals (e.g. actuator)
PPM Cable
RED: Power (5 V)
BLACK: Signal GND
WHITE: PPM signal (0-5 V)
Antennas
Loading ...
Loading ...
Loading ...