Loading ...
Loading ...
Loading ...
55
en
Service programmes
A
Warning!
For each of the service programmes,
use descaling and cleaning agents
as described in the instructions and
observe the (relevant) safety infor-
mation�
Never interrupt a service programme�
Do not drink liquids!
Never use citric acid, vinegar or any
vinegar-based agents to descale the
appliance� Never place descaling
tablets or other descaling materials in
the ground coee drawer!
F
Important:
Before starting each service program
(Descale, Clean or calc’nClean)
remove the brewing unit, clean as
instructed and replace it�
Be careful not to jam the milk tube
when closing the door�
After completion of each service
programme, wipe the appliance
immediately with a soft, damp cloth
to remove any residues from the
descaling and cleaning solution� It is
possible for corrosion to form under-
neath such deposits�
New sponge cloths may contain
salts� Salts can cause rust film on
stainless steel and must therefore be
washed out thoroughly before use�
Clean the beverage outlet, milk tubes
and connecting piece thoroughly�
Specially developed, suitable
descaling and cleaning tablets are
available from retail outlets or from
customer services (see the section
“Accessories”)�
F
Using a water filter increases the
intervals until a descaling pro-
gramme needs to be performed�
Descaling
Takes about 21 minutes�
■ Press button E�
■ Turn the rotary selector to select “Descale”�
■ Press button C� Display indi-
cates progress of the programme�
■ Empty drip trays and replace�
■ Remove water lter(if there is one) and
press C�
■ Pour lukewarm water into the empty
water tank up to the “0�5 l” mark and then
dissolve one Siemens descaling tablet
TZ80002N in it�
F
If there is not enough descaling
solution in the water tank, you will
be asked to do the following. Refill
using uncarbonated water and press
C again�
■ Remove the suction pipe from milk
container, wipe it and insert the end of the
suction pipe into the hole on the coee
grounds container�
■ Close the appliance door�
■ Place a container with a capacity of
0�5 litre under the beverage outlet�
■ Press button C� The descaling
programme will now run for about
19 minutes�
■ Remove the container and press
C�
■ Rinse the water tank and (if removed)
replace the water lter.
■ Fill the tank with fresh water up to the
“max” indicator�
■ Replace the water tank and close the door.
■ Place the container underneath the
beverage outlet again�
■ Press button C� The desca-
ling programme will now run for about
2 minutes and rinse the appliance�
■ Remove the container, empty the drip
trays, replace and close the appliance
door�
■ Press C� The appliance has
nished descaling and is ready for use
again�
■ Press E to exit the program�
Loading ...
Loading ...
Loading ...