Loading ...
Loading ...
Loading ...
10
Control Knobs
The cooktop has one control knob for each burner. Push
in and turn to the left to light and set the desired heat
setting.
9 WARNING
Failure to operate knobs properly may result in
personal injury and damage to the appliance.
The cooktop has standard burner controls.
To operate
Select the appropriate control knob, push in and turn
counterclockwise to the desired flame size. Turn off by
turning the control knob clockwise to off.
In Case of Power Failure
In the event of a power failure, the burners may be lit with
a match. Press the control knob for the selected burner
and turn it counterclockwise to the highest power setting.
Carefully hold a lit lighter or match against the burner.
Flame Failure Safety System
Your rangetop is equipped with a safety system that cuts
off the gas when the burners are accidently turned off. To
ensure that this device is active: Turn on the burner as
usual. Without releasing the control knob, press and hold
it in firmly for 4seconds after lighting the flame.
Normal Operation - Electronic Ignition
The cooktop uses electronic igniters to light the burners.
There is no pilot light. Each burner has its own igniter. All
igniters are activated when a control knob is pushed.
9 CAUTION
To avoid possible injury or damage to the
appliance, ensure grates are installed exactly per
installation instructions and not backwards or
upside down.
The igniter should be clean and dry for proper operation.
▯ Avoid getting water or food on the igniter.
▯ If the igniter is wet or soiled, it may spark without
igniting the burner, or even spark continuously when a
flame is present.
Note: If the burner does not light within 4 seconds, turn
the burner off. Check to see that the burner cap is
positioned correctly on the burner base and the igniter is
clean and dry. Wait at least 5 minutes before igniting the
burner again. If a burner still fails to ignite, see “Before
Calling for Service”.
When a flame is present and a Low setting is used, the
igniter may occasionally spark. This is normal.
Turning off a burner
Turn the corresponding control knob clockwise to the
"off" position.
If the flame goes out
Switch off the control knob. Wait 5 minutes and switch
the burner on again.
9 WARNING
RISK OF DEFLAGRATION
If the burner does not ignite after 15 seconds,
switch off the control knob and open the door or
window in the room. Wait at least 5minutes before
igniting the burner again.
OptiSim® Feature
OptiSim® has been designed to work with the small
burner in the right rear position of the rangetop and is
used to provide optimal simmering for delicate sauces
while minimizing the risk of scorching.
OptiSim® Burner Cap Installation
When properly installed the cap will extend beyond the
burner base and raised surface.
Symbol Meaning
off Cooking zone switched off
min Minimum power
max Maximum power
o Inner flame switched on
ð
Inner and outer flame switched on
Loading ...
Loading ...
Loading ...