Loading ...
Loading ...
Loading ...
820685
48
TROUBLESHOOTING AND ERROR TABLE
Problem/
error
Indication on the display unit and
problem description
What to do?
E0 Incorrect settings
Restart the programme. If the error reoccurs,
call a service technician.
E1 Temperature sensor error.
Inlet water too cold. Repeat the washing
programme.
If the washing machine reports this error again,
call a service technician.
E2 Door lock error.
Make sure the washing machine door is closed.
Unplug the power cord from the outlet; then,
plug the power cord back into the outlet and
switch on the washing machine.
If the error reoccurs, call a service technician.
E3 Water filling error.
Check the following:
• is the water inlet valve open,
• is the filter on the water supply hose clean,
• is the water supply hose deformed (clipped,
clogged etc.),
• is the pressure in the water mains between
0.05 and 0.8 MPa (0,5–8 bar).
Then, press the (3) START/PAUSE button to
resume the programme. If the error reoccurs,
call a service technician.
E4 Motor error Restart the programme. If the error reoccurs,
call a service technician.
E5 Motor error
Restart the programme. If the error reoccurs,
call a service technician.
E6 Water heating error Restart the programme. If the error reoccurs,
call a service technician.
E7 Water draining error
Check the following:
• is the pump filter clean,
• is the discharge hose clogged,
• is the drain clogged,
• if the discharge hose placed is placed below
the maximum and above the minimum
height (see chapter »INSTALLATION AND
CONNECTION/ Connecting and securing the
water discharge hose«);
then, press the (3) START/PAUSE button
again. If the error reoccurs, call a service
technician.
Loading ...
Loading ...
Loading ...