Loading ...
Loading ...
Loading ...
8
Style 2—with Grille
Your freezer has 2 front adjustable legs — one on each side. The
back of the freezer rests on 2 fixed rollers. The base grille covers
the adjustable brake feet and roller assemblies located at the
bottom of the freezer below the freezer door. Before making any
adjustments, remove the base grille and move the freezer to its
final location.
Tools Needed: 1/4" hex driver, Phillips head screwdriver
1. Remove the base grille screws. Grasp the grille rmly and
pull it toward you. Open the freezer door to access the brake
feet.
NOTE: To allow the freezer to roll more easily, raise the brake
feet by turning them counterclockwise. The front rollers will
be touching the floor.
2. Move the freezer to its nal location.
3. Lower the brake feet, by turning them clockwise, until the
rollers are off the oor and both brake feet are snug against
the oor. This keeps the freezer from rolling forward when
you are opening the freezer door.
IMPORTANT: If you need to make further adjustments
involving the brake feet, you must turn both brake feet the
same amount to keep the freezer level.
4. Make sure the door closes easily. If you are satised with the
door opening and closing, skip the next section. If, however,
the door does not close easily or the door pops open, adjust
the tilt.
To Adjust the Cabinet Tilt:
NOTE: Having someone push against the top of the freezer
takes some weight off the brake feet. This makes it easier to turn
them. Open the freezer door. Use a 1/4" hex driver to turn both
brake feet clockwise the same amount. This will raise the front of
the freezer. It may take several turns to allow the door to close
more easily.
5. Make sure the freezer is steady. If the freezer seems
unsteady or rolls forward when the door is pulled open,
adjust the brake feet.
To Steady the Freezer:
■ Open the freezer door. Using a 1/4" hex driver, turn both
brake feet clockwise the same amount until the brake feet
are snug against the oor. Check again. If not satised,
continue to adjust the brake feet by half turns of the screw
until the freezer does not roll forward when the door is
opened.
6. Replace the base grille by aligning the ends of the grille with
the leveling assemblies on each side and snapping the grille
into place. Reinstall the Phillips screws.
Ensuring Proper Air Circulation
In order to ensure proper temperature,
you need to permit proper airflow in
the freezer. As shown in the illustration,
cool air enters from the freezer wall and
moves down. The air then recirculates
through the vent near the bottom.
Do not block any of these vents with
food packages. If the vents are blocked,
airflow will be restricted and temperature
and moisture problems may occur.
IMPORTANT: To avoid odor transfer and
drying out of food, wrap or cover foods
tightly.
Using the Control
The temperature control is located at the top front of the freezer
compartment.
Temperature Control
For your convenience, the temperature control is preset at the
factory. When you first install your freezer, check that the control
is still set to the recommended setting as shown.
IMPORTANT:
■ The recommended setting is designed to maintain the
temperature at or near 0°F (-17.8°C) under normal operating
conditions.
■ Allow the freezer to cool 6 to 8 hours before filling with frozen
food.
A
C
B
A. Brake foot
B. Front roller
C. 1/4" hex driver
OPERATING YOUR FREEZER
Loading ...
Loading ...
Loading ...