Loading ...
Loading ...
Loading ...
43
EN
CAUTION: the safety precautions are part of the
appliance. Read them carefully before using your
new appliance for the first time. Keep them in a
place where you can find and refer to them later on.
DESCRIPTION
A Motor Unit
B Blender bottle assembly
B1 Blade unit
B2 Seal
B3 Plastic bottle
C Lid Assembly
C1 Lid Seal
C2 Lid
D Plastic stick (for removing the lid seal)
SAFETY LOCKING SYSTEM
The appliance will not operate if the blender bottle assembly (B1 + B2 + B3) is not correctly
assembled and correctly positioned on the motor unit (A).
BEFORE USING FOR THE FIRST TIME
Before using for the first time wash the blender assembly (B) and lid assembly (C), in warm
water and a little washing-up liquid. ATTENTION: DO NOT IMMERSE THE MOTOR UNIT (A) OR PUT IT
UNDER WATER OR ANY OTHER LIQUID. Clean with a damp cloth then dry it carefully.
WARNING: The cutter blades are extremely sharp, handle them with caution during use,
cleaning or on emptying the bottle. Do not fit the blade unit onto the motor unit by itself.
Make sure that all packaging has been removed before operating the appliance.
INTRODUCTION
This blender will allow you to discover a new world of textures: liquids, chopped fruits and finely
ground powders for culinary use. Using it, you can blend some simple ingredients to obtain
delicious recipes.
USING YOUR APPLIANCE
• Place the motor unit (A) on a flat, stable, heat-resistant surface away from sources of heat or
water splashes, and plug into a wall socket.
• Fill the blender bottle (B3) with ingredients. The maximum level is 600 ml (see marking on
bottle) and must not be exceeded. For best results, we recommend filling the bottle with liquid
ingredients first and then fresh/frozen ingredients (cut the ingredients into pieces no larger
than 2 cm). Do not overfill the bottle.
• Screw the blade unit with seal (B1+B2) securely on to the open end of the blender bottle
(B3) Fig.1. Turn the bottle upside down so that the blade unit is at the bottom, then align
the arrow on the exterior of the blade unit with the arrow on the edge of the motor unit Fig.2.
Loading ...
Loading ...
Loading ...