Loading ...
Loading ...
Loading ...
en Faults and what to do about them
36
Information on the display panel
Faults and what to do about them.
Display Cause/remedy
è lights up ■ The temperature is too high. Wait until the temperature drops.
■ The water level is too high. It is not possible to add laundry. Close the door
immediately, if necessary. Press the Start Reload A button to continue the
programme.
è flashes ■ Laundry may be caught. Open and close the door again and press the Start
Reload A button.
■ If necessary, push the door closed or remove some laundry and then push it
closed again.
■ If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
r lights up ■ Turn on the cold water tap fully,
■ Supply hose kinked/trapped,
■ The water pressure is too low. Clean the filter. ~ Page 34
“: ‚‰ ■ The drain pump is blocked. Clean the drain pump. ~ Page 33
■ The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
~ Page 34
“: ƒ„ There is water in the base plate, the appliance is leaking. Turn off the tap. Call the
after-sales service. ~ Page 38
“: „ƒ flashes alternately with “Ÿš at the end of the programme.
Not a fault – the unbalanced load detection system has interrupted the spin cycle
because the laundry is unevenly distributed.
Distribute small and large items of washing in the drum. If required, spin the laundry
once more.
E The childproof lock is activated – deactivate it. ~ Page 28
Other displays Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call the after-sales service. ~ Page 38
* depending on the model
Faults Cause/Remedy
Water is leaking from the
appliance.
■ Attach the drain hose correctly or replace it.
■ Tighten the screw connection of the drain hose.
The machine is not filling
with water.
Detergent is not being dis-
pensed.
■ Have you pressed the Start Reload A button?
■ Is the tap turned on?
■ Could the filter be clogged? Clean the filter. ~ Page 34
■ Is the supply hose kinked or trapped?
Loading ...
Loading ...
Loading ...