Loading ...
Loading ...
Loading ...
Tape measure
Carpenter square
Electric drill with hole bit
Gloves
Level
Safety goggles
Flashlight
8
Installation Instructions - Intergrated Application
Preparing the
Enclosure
Tools You Will Need
The appliance must be
connected to an individual
properly grounded electrical
outlet, protected by a 15 or
20 ampere circuit breaker or
time delay fuse.
• It is recommended that you do
not install the Wine Cooler
into a corner (i.e. directly beside
a wall). This is to allow the
door(s) to have a greater then
90° opening swing. A limited
door swing will prevent the
shelves from sliding out as
intended, and may lead to dam-
aging the door gasket(s).
• The rough cabinet opening
must be on a level floor area
and at least 24
14
/16” deep
(63.2cm) by 15
3
/16 ”(38.6cm)
wide. The opening should also
have a height of at least
34
3
/16 ”(86.8 cm).
• The electrical outlet may be
positioned from within either
side of the adjacent cabinetry
, or
the rear of the shaded area (as
shown in Fig D).
• If the electrical outlet is located
inside the adjacent cabinetry, cut
a 1
1
/2”(3.81cm) diameter hole to
admit the power cord. If the cabi-
net wall is metal, the hole edge
must be covered with a bushing
or grommet.
Electrical Requirements:
Important： If the electrical outlet
is surface mounted (not flush)
within the enclosure, the depth
requirement for the installation
may be affected.
NOTE: This unit is front breathing.
Do not block the front air vent. Blockage
of the vent will result in high operating
temperatures and system failure. (Fig.E)
FOR YOUR SAFETY
While preforming
installations described
in this section. gloves,
safety glasses or
goggles should be
worn
15
3
/
16
”
1
1
/
2
” dia hole
*If electrical outlet
is in adjacent cabinetry
1
3
/
16
”
34
3
/
16
”
From underside
of countertop
to floor
6”
24
14
/16”
min
Cabinet is
square
and plumb
Electrical Access
*the listed depth requirement for the installation is assuming that
the electrical outlet is located in the adjacent cabinetry or is flush
mounted in the rear wall, not surface mounted in the enclousre.
Loading ...
Loading ...
Loading ...