Loading ...
Loading ...
Loading ...
o The hanging plate should be securely fixed to the ceiling, using
the 40 mm x ST6 screws (9 pcs) and wall plugs (IMPORTANT:
See note regarding wall plugs on page 19).
o Depending on the surface of the ceiling that you are fixing the
hanging plate to, you may need to use six expansion bolts (for
concrete).
2) Extend the angle bars to the required height, then
fix them in position using the 10 mm x M4 nuts and
bolts with metal washers (12 pcs) (as shown in the
line drawing opposite).
o IMPORTANT: The angle bars must have an
overlap of AT LEAST 100 mm.
o Fix a connector piece to the
bottom of each angle bar using
the 10 mm x M4 nuts and bolts
with metal washers (12 pcs).
3) If you are going to be using the hood in
extraction mode, you should fit the spigot
for the duct hose onto the main body of the
cooker hood using the self tapping screws
(4 pcs)
o Place the angle bars inside of the
main body of the cooker hood.
o Place the upper chimney section onto
the main body of the cooker hood.
25
Loading ...
Loading ...
Loading ...