Loading ...
Loading ...
Loading ...
10. Move to desired location.
11. Remove shipping cones using a 3/4” socket or wrench.
12. Remove bolt from shipping cone with hammer. Recycle cone.
13. Attach foot pads to each foot of frame.
Install weight plates
1. Lean guide rods slightly outward, away from machine, DO NOT put excessive pressure on guide rods, it will damage lower guide
rod caps.
2. Wipe the entire length of the guide rods with a clean cloth.
3. Lubricate the guide rods with a light coating of medium weight oil.
4. Install each weight plate, one at a time, so wide edge of bushing faces upward (1) and narrow edge of bushing (2) faces downward.
Correct: Wide bushing edge upward Incorrect: Narrow bushing edge downward.
5. Install liing post.
6. Install compression spring and top guide rod cap onto guide rod. Slide spring loaded top guide rod cap down guide rod until cap
is clear of guide rod plate and install. Repeat for opposite side.
Apply weight plate decal
1. Peel o half of backing from weight plate decals, making sure that the decals remain attached to the front sheet.
Item Description Qty
1 Backing 1
2 Front sheet 1
3 Weight decals 1
2. Place decals front sheet in the correct position on weight plates.
3. Insert a guide pin through each hole of the decals front sheet. A guide pin can be anything that fits through the weight stack hole,
such as a weight stack selector pin.
4. Align decals and rub them onto weight plates.
Page 10 of 22
Loading ...
Loading ...
Loading ...