Loading ...
Loading ...
Loading ...
22
For dry mop cleaning
1
Empty the water in the water tank.
2
Attach the dry mop pad to the mop attachment
plate at the bottom of the mop nozzle.
3
Set the Water Adjustment button to STOP.
4
Turn on the power and begin mopping
WARNING
•
Do not insert your hand into the moving rotor. It may
result in injury.
•
Do not attach the mop pad while the mop nozzle is
operating. It may result in injury.
CAUTION
•
Do not slam down or throw the mop nozzle onto the
floor.
Doing so may result in an injury or product damage.
•
Do not let the product stand on the floor while the
wet mop plates are attached.
Doing so may result in damage or swelling to timber
flooring.
•
Set the Water Adjustment button to STOP when not
using the product for an extended period of time.
Otherwise it may result in a product failure.
•
Do not use any other mop pad other than the one
provided.
•
Do not put liquid other than water in the water tank.
•
Do not put hot water in the water tank.
•
Do not step on the mop nozzle. It may result in
product damage
•
After cleaning, remove the remaining water in the mop
nozzle with a tissue before storing. The water may
leak and damage the floor.
•
Do not pull on the marked rubber. It may tear.
Please note
•
When using a mop, clean using straight lines and
diagonal lines.
•
Wet the mop and squeeze it sufficiently to remove
any residual water before attaching the mop.
Attaching and using a mop pad in a dry state may
compromise the cleaning performance.
•
When filling the water tank with water, do not fill the
water more than the MAX line.
•
Do not separate the cap of the water tank completely.
•
Open only one cap of the water tank to fill the water.
•
When cleaning is completed, always empty the water
in the water tank.
Otherwise the water may be contaminated and give
off a bad smell.
Shake the water tank to remove the remaining water.
•
Open the 2 caps on the side of the water tank and dry
for over 24 hours in a well-ventilated location with no
direct sunlight.
•
When cleaning with the mop is finished, separate and
wash the mop pads.
Otherwise the mop pads may give off a bad smell.
•
Do not clean while a soiled mop pad is installed.
Cleaning will not be effective.
•
From new, the Water Adjustment button is set to
Level 1.
Press the button according to the amount of water
needed.
•
When moving around with the mop nozzle, set the
Water Adjustment button to STOP.
•
If there are foreign objects stuck in the mop
attachment plate's rotating mechanism or a strong
force or impact is applied to it, the mop attachment
plate will stop automatically to protect the product.
Press the Power button again to use the product
because it is not a failure. Clean any foreign matter
from the plate before turning it back on again.
Loading ...
Loading ...
Loading ...